Nauticam 17960 User manual

Current as of 2022-05-16
Baseboard
Instruction Manual for Universal
Quadra-Pod Plate for Nauticam
Housings
PN#17960
FOREWORD
Thank you for your purchase of a NAUTICAM product.
At NAUTICAM, we pride ourselves in the ability to recognize the requirements
of professional as well as amateur underwater photographers and fulfill them
through the innovative designs of our products. We strive to achieve a high
level of user-friendliness by allowing stress-free installation and easyoperation
of all important functions of the camera.
Please read this manual carefully before using the product, this will maximize
its performance as well as its lifetime.
WARRANTY
All NAUTICAM Products are warranted against any material and
manufacturing defects for two years from the date of purchase for consumer
use. This warranty only applies to products purchased from authorized
NAUTICAM dealers and does not extend beyond the original retail purchaser.
To return your product for service, please contact your regional authorized
service center(s). Please note that this warranty only applies when the product
is purchased in the territory where the service center is located.
NAUTICAM does not hold responsibility for damage, of any nature, to any
equipment used with and/or placed within our products.
NAUTICAM accepts no liability for any loss of captured images or the
inability to capture images even if it is due to the malfunctioning of our
products.
Unauthorized modifications and/or repairs of our products will automatically
invalidate the warranty.
Baseboard
45°Mounting Ball x 4
1/4"-20UNC Screw x 2
Thumb Screw x 4
IDENTIFICATION OF PARTS
INSTALL THE QUADRA-POD PLATE TO A HOUSING
Align the guiding points and attach 45°mounting ball to the designated area,
and tighten it with the thumb screw by clockwise.
Mount the four 45°mounting balls to the baseboard as shown.
Align with the 1/4"-20UNC thread hole of housing, and attach the Quadra-
Pod Plate to the bottom of the housing.
PACKAGE CONTENTS
Thumb Screws (x4)
1/4"-20UNC Screw (x2)
45°Mounting Ball (x4)

Current as of 2022-05-16
Tighten it with the two 1/4"-20UNC screws provided.
To remove the Quadra-Pod Plate, reverse the above steps.
The Quadra-Pod can be used in either Quadra-pod or Tripod configurations
via adjusting the position of mounting ball as shown.
The Quadra-pod plate on a housing.
SPECIFICATIONS
17960 UNIVERSAL QUADRA-POD PLATE FOR NAUTICAM HOUSINGS
Dimensions(mm):
210.0 x 164.0 x 55.0
Weight(kg):
0.56
Compatible housings:
- N120 DSLR and Mirrorless Housings
- N100 Sony/Fujifilm, Nikon Housings
- N85 Mirrorless Housings
Incompatible housings:
Cinema housings
Remark: Nauticam supports only e-manuals. Please download corresponding
product manuals on Nauticam.com website, or contact us for e-manuals.
CONFIGURATIONS OF THE QUADRA-POD PLATE