Nauticam 86221 User manual

Current as of 2019-12-27
Instruction Manual for
M67 Flip Holder/Double Flip Holder for
MWL-1
PN# 86221, #86222
F
OREWORD
Thank you for your purchase of a NAUTICAM product.
At NAUTICAM, e pride ourselves in the ability to recognize the
requirements of professional as ell as amateur under ater
photographers and fulfill them through the innovative designs of our
products. We strive to achieve a high level of user-friendliness by
allo ing stress-free installation and easy operation of all important
functions of the camera.
Please read this manual carefully before using the product, this ill
maximize its performance as ell as its lifetime.
W
RR NTY
All NAUTICAM Products are arranted against any material and
manufacturing defects for t o years from the date of purchase for
consumer use. This arranty only applies to products purchased from
authorized NAUTICAM dealers and does not extend beyond the original
retail purchaser.
To return your product for service, please contact your regional
authorized service center(s). Please note that this arranty only applies
hen the product is purchased in the territory here the service center
is located.
NAUTICAM does not hold responsibility for damage, of any nature, to
any equipment used ith and/or placed ithin our products.
NAUTICAM accepts no liability for any loss of captured images or the
inability to capture images even if it is due to the malfunctioning of our
products.
Unauthorized modifications and/or repairs of our products ill
automatically invalidate the arranty.
Press the lever and flip the holder to the side then remove the
locking ring from the flip holder.
Align the t o positioning scre s on the back of the holder ith
the slots on the front of the port.
The position of the flip holder can be changed by relocating the
t o scre s in the threaded holes around holder.
Fasten the holder by scre ing the locking ring into the thread
on the front of the port.
---Continue on next page---
INST LL
TO
THE
PORT
Press

Current as of 2019-12-27
---Continue from front page---
C
H NGING THE
M
OUNTING
R
ING
A M67 mounting ring is supplied for directly mounting MWL-1
on the flip holder.
Follo belo instruction to exchange the Bayonet Mounting
Ring of MWL-1 to M67 Mounting Ring in order to be securely
Remove the 7x scre s from the back of the lens.
Remove the bayonet mounting ring of MWL-1. Note that there
are 4x small black cylindrical positioning pins. All 4 pins should
be remain in the back of the lens
Locate the 4 small sockets of the M67 mounting ring. Align ith
the positioning pins on the MWL-1 and place it on top.
Secure the mounting ring by tightening the 7x scre s
Fastening the MWL-1 tightly on M67 flip holder or double flip
holder. Please refer to MWL-1 to adjusting the lens hood
position
Remark: Nauticam supports only e-manuals. Please do nload corresponding
product manuals on Nauticam.com ebsite, or contact us for e-manuals.