Current as of 2019-04-08
36478 N100 flat port 40 (for fujifilm
XC 15-45 PZ to use with L-1)
Instruction Manual
ORE ORD
Thank you for your purchase of a NAUTICAM product.
At NAUTICAM, we pride ourselves in the ability to recogni e the requirements
of professional as well as amateur underwater photographers and fulfill them
through the innovative designs of our products. We strive to achieve a high
level of user-friendliness by allowing stress-free installation and easy
operation of all important functions of the camera.
Please read this manual carefully before using the product, this will maximi e
its performance as well as its lifetime.
ARRANTY
All NAUTICAM Products are warranted against any material and
manufacturing defects for two years from the date of purchase for consumer
use.
This warranty only applies to products purchased from authori ed
NAUTICAM dealers and does not extend beyond the original retail purchaser.
To return your product for service, please contact your regional authori ed
service centre(s). Please note that this warranty only applies when the product
is purchased in the territory where the service centre is located.
NAUTICAM does not hold responsibility for damage, of any nature, to any
equipment used with and/or placed within our products.
NAUTICAM accepts no liability for any loss of captured images or the inability
to capture images even if it is due to the malfunctioning of our products.
Unauthori ed modifications and/or repairs of our products will automatically
invalidate the warranty.
OUNTING THE PORT ON THE HOUSING
OUNTING
ON THE PORT
1. Attaching M67 Bayonet mount converter is required
before attaching WWL-1 on the port.
Align the two positioning pins on the back of the
converter with the slots on the front of the port. Fasten
the convertor on the front of the port with the tool
provided.
2. Align the port mounting indicates of the port and
the housing.
Gently push the port into the port opening of the
housing, until it cannot go in any further.
3. Lock the port into place by turning the port
locking lever to the inward position. To ensure
that the port is securely mounted, confirm that
the green line on the safety button of the port
locking lever is visible.
1. Align the “I” mark on the WWL-1 lens with the “I”
mark on the converter and then push it in.
