Nav TV NTV-KIT607 NNG-Toyota 2 User manual

NNG-Toyota 2
Navigation interface for select Toyota vehicles
NTV-KIT607
NTV-DOC229
3950 NW 120th Ave, Coral Springs, FL 33065 TEL [phone] FAX [phone]

Installation Guide
Remove A/C VENT Remove 4 Screws from radio
STEP 1 STEP 2
REMOVED RADIO
STEP 3 STEP 4
STEP 5
Remove radio mount
Navigation For RAV4
REMOVEDCLIP
STEP 6
Remove all screws to open up the LCD screenREMOVED CLIP
NTV-DOC229
NTV-DOC229

Installation Guide
Navigation For RAV4
1. Place Mask tape on radio to avoid drilling scrap
2. At bottom of the radio, center of the radio, drill a hole
Drill a Hole to run Video Cable
1. Place the Touch screen ribbon in factory LCD Screen board
2. Place the Factory Touch Screen Ribbon into daugther board (As a Y-Connection)
1. Place the LCD ribbon in the factory LCD Screen board
2. Place the Factory LCD Ribbon into daugther board ( As a Y-Connection)
NTV-DOC229

Installation Guide
Navigation For RAV4
Place 3 Spacers and 3 Screwsn to the red circle position
Install Video Board
Place Radio ribbon from Radio side to video board socket
Run the Video Cable from inside
video board to outside the radio
NTV-DOC229

Installation Guide
Navigation For RAV4
Overall Wiring Figure
Connect the Following:
TP IN (Yellow)
LCD OUT (PINK)
REAR LCD
Power Connector
GPS Antenna
External Speaker
External Switch
1. Place the 10PIN (NON-JBL ) or 20PIN ( JBL) Power Harness
2. Place the Module under the Radio
NTV-DOC229

Installation Guide
Navigation For RAV4
DIP SW Setting
1 ON OEM Camera / NO camera
1 OFF Aftermarket Camera
2-8 OFF
IF 28PIN T-Harness DO NOT include in the package
Please connect reverse wire manually
Don't Forget to Connect REVERSE WIRE to activate
OEM Camera
Activate OEM Camera/ After Market Camera
Manually Connect 28 PIN Connector PIN#2 ((Orange Wire)
From the Radio to Black 8 Pin Connector PIN#5 (Orange Wire)
Reverse Signal is on 28PIN #2 (Orange Wire)
Press and Hold Factory Screen 3 Seconds to
Activate Radio/GPS Mode
REMINDER!!
NTV-DOC229

NTV-DOC229

WEAK /NO GPS SIGNAL?
Tips to Improve GPS Antenna Signal if vehicle equipped Metallized Windshield*
“GPS MONITOR Tools”
Exit IGO MAP by press SHUT DOWN BUTTON
Console> SETUP GPS MONITOR
Locate the Antenna with minimum 5 bars in dark blue or Gray bar
(Always suggest mounting the GPS antenna on the roof)
Press “!” icon to reset GPS signal and change the Antenna position
NTV-DOC229

PROPER GPS ANTENNA POSITION
if vehicle equipped *Metallized Windshield
SUV/Coupe
Sedan
TRUCK (Shown as Tundra)
Alternatively, installer might choose to mount Antenna inside the headliner or inside
vehicle using GPS monitor tools (see instruction). However, stay away from the
windshield.
*Windshields with metal particles can interfere with radio waves, dash-mount satellite radio receivers, and GPS
receivers may be affected external transmitters and receivers may be required.
NTV-DOC229

IGOPRIMOMAPPATHSETTING
1. PressSetup‐>NavigateSetup
2. PressontheFolderIcon
3. SelectthefollowingpathinStorageCard‐>cyb_navi.exe
4. PressHOMEbuttononthetopleftcornerandpress
NAVIGATION
5. Systemshouldabletoruninto“IGOPRIMO”