NCR 7610-K453 Manual

7610-K453
LCD Customer Display Tilt
Mount
Kit Instructions
Issue A

Revision Record
Issue
Date
Remarks
A
Feb 2011
First issue

1
Introduction
This kit provides a VESA tilt mount which supports 6.5”, 12.1” and 15” NCR LCD customer
displays. Includes (4) VESA mount screws for NCR 12 & 15” LCDs and (4) VESA mount
screws for 5982 (6.5”) LCD.
Note: This kit requires the Customer Display Base Kit (7610-K452).
Warning: The 7610-K452, 7610-K453 and LCD customer display should be
disconnected from the terminal during movement / shipping.
29175
Customer Display Base (7610-K452)
LCD Customer Display Tilt Mount (7610-K453)
Components
29176
Customer Display Pole
497-0470829
Dome Plug
006-8611578
Tilt MountAssembly
497-0451954
Screw, 6-32 x 0.312, Phil, Pan Hd, Black (5982 LCD)
006-8611307
Screw, M4 x 10, Phil, Pan Hd, Black (12” and 15” NCR Displays)
006-8608194

2
Installation Procedures
1. Install the Tilt Mount Assembly on the back of the LCD Customer Display. Use
the M4 x 10 screws for the 12” and 15” NCR Displays or the 6-32 x 0.312 screws for
the NCR 5982 Display. (The M4 screw has a larger diameter than the 6-32.)
29177
Tilt MountAssembly
2. Install the Customer Display Base (7610-K452) on the back of the 7610 Table Top
Stand (7610-K320). Secure it with screws (2).
29179
Customer Display Base
7610 Table Top Stand

3
3. Insert the Customer Display Pole into the Customer Display Base.
29180
Customer Display Pole
4. Connect the Display Cables (DVI/VGA and Powered USB) to the Customer
Display.
5. Route the Display Cable down the Customer Display Pole.
6. Connect cables to I/O Panel connectors on the 7610.
7. Insert the Customer Display Pole into the Customer Display Base.
29181

4
8. Align the hole in the Customer Display Pole with the slot in the Tilt Mount
Assembly and then insert the Dome Plug into the hole. The plug locks the plastic
components together.
29282
Dome Plug