Neoray S23DW User manual

TM
100 Andrews Rd, Hicksville, NY 11801 • p: 516-470-1000 • f: 516-470-1077 • www.neoray-lighting.com Page 1 of 3
Document P/N: 23DW02
S23DW CONTINUOUS INSTALLATION INSTRUCTIONS
1. REMOVE LENS.
AND WALL MOUNTING
BRACKETS.
BEND DOWN SOCKET
TRAY AT ENDS.
2. INSTALL WALL MOUNTING BRACKETS BY PLAN ON
WALL USING WOODEN SCREW(OR 8-32 SCREW ON
JUNCTION BOX)(NOT FROM NEORAY).
PUSH THROUGH FEED CORD IN TO FEED HOLE
OF MOUNTING BRACKET BOR FIXTURE.
BRING BOR FIXTURE UP TO WALL.
NOTE: WE RECOMMEND TO MOUNT FIXTURE
TO WALL BY WOODEN SCREW WITH
WASHER(NOT BY NEO-RAY).
FIXTURE WITH FEED MAY BE INSTALL
OVER JUNCTION BOX.
IF IT IS NECESSARY, CONTRACTOR HAVE
TO PROVIDE BLOCKS AT PLACE OF FIXTURE
MOUNTING POINTS.
3. PUSH FEED CORD THROUGH FEED HOLE OF BOR FIXTURE,
HANG UP BOR FIXTURE ON WALL MOUNTING
BRACKET AND FIX BY SCREW

TM
100 Andrews Rd, Hicksville, NY 11801 • p: 516-470-1000 • f: 516-470-1077 • www.neoray-lighting.com Page 2 of 3
Document P/N: 23DW02
S23DW CONTINUOUS INSTALLATION INSTRUCTIONS
4. INSTALL
STRAIN
RELIEF
5. SPLICE WIRES
8-32 Machine
Screw
6. BEND TRAY UP.
FIX WITH 8-32
MACHINE SCREW
7. INSTALL WALL MOUNTING BRACKET
OF INT FIXTURE BY PLAN AND FIX IT
TO WALL BY WOODEN SCREW.
BRING INT FIXTURE TO INSTALLED
BOR FIXTURE.
8. INSTALL INT FIXTURE ON WALL MOUNTING
BRACKET

TM
100 Andrews Rd, Hicksville, NY 11801 • p: 516-470-1000 • f: 516-470-1077 • www.neoray-lighting.com Page 3 of 3
Document P/N: 23DW02
S23DW CONTINUOUS INSTALLATION INSTRUCTIONS
Carriage Bolt
Aligner Pin
BOR Section
Bulkhead Opening
Joiner Nut
INT Section
11. SPLICE RUN THROUGH WIRES.
BEND TRAYS UP. FIX WITH 8-32
MACHINE SCREWS.
13. INSTALL LAMPS.
14. CHECK FIXTURE FUNCTION.
15. INSTALL LENSES.
9. CONNECT INT FIXTURE TO INSTALLED BOR FIXTURE
BY CARRIAGE BOLT THROUGH HOLE IN BLACKHEAD
OF INT FIXTURE, PUT NUT ON A FEW THREADS.
10. INSERT ALIGNER PINS INTO ADJACENT HOUSING OF
INT FIXTURE GROOVES.
12. REPEAT STEPS FROM
7 THROUGH 11 TO
CREATE RUN.
10. WITH SUPPORT INT FIXTURE
TIGHTEN JOINER NUT.