NetComm Freshtel NB9W Use and care manual

NB9W ADSL2+ IAD
Firmware Upgrade Instructions
Please follow these steps to upgrade your NB9W firmware:
1. Connect to your NB9W using an Ethernet cable. It is advised that you do not perform
the upgrade wirelessly.
2. Open a web browser (e.g. Internet Explorer) and enter http://192.168.1.1 into the
Address bar:
3. Click Management ÆDevice Settings ÆUpdate Firmware:
1

4. Click Browse and choose the binary file that you downloaded from NetComm’s website
(e.g. NB9W_C09_R02.bin) and click Update Software:
5. Wait for approximately 3 minutes for your NB9W to complete the upgrade.
NOTE: DO NOT DISCONNECT YOUR PC FROM THE MODEM or POWER THE NB9W OFF!
6. Reset your NB9W to its factory default settings.
7. Login and configure the settings again.
8. Done!
2