NETCOMM 210P VoIP
ATA CONNECTION GUIDE
WElCOME TO ClUbTElCO
We have pre-congured your ATA (Analog Telephone
Adaptor) for you - just follow these steps to start using
your ClubTelco VoIP service.
STEP 1 - CONNECT ThE ATA TO yOUr PC
Connect an Ethernet Cable to the back of your computer
and the other end of the cable to the port labelled LAN on
the back of the ATA.
STEP 2 - CONNECT ThE ATA TO yOUr MODEM
Connect another Ethernet Cable to the LAN (Ethernet)
port on your modem/router and then the other end of the
cable to the WAN port on the back of the ATA.
STEP 3 - CONNECT ThE ATA TO yOUr PhONE
Once you have plugged the ATA into the computer and
modem, connect a standard Telephone Cable from the port
labelled Phone on the ATA and the other end of that cable
to the phone you wish to use to make your calls.
STEP 4 - CONNECT ThE ATA TO yOUr PhONE lINE
Your nal step is to connect another phone cable to the
port labelled LINE and the other end of that cable to the
LINE port on your ADSL Filter (this is sometimes called the
PHONE port).
IMPORTANT NOTICE
2
3
1
4
Before beginning use of your new ClubTelco VoIP service please be sure to make a test call to a phone that has
calling number display (your mobile phone will suit). When you make the call, conrm that it is your new VoIP
number that is displayed on the caller ID - if it is, then you are set up correctly and can begin using your new VoIP
service. If your VoIP phone number is not displayed please contact ClubTelco Technical Support on 13 8352 ASAP
for help setting up your device. ClubTelco will not take any responsibility for PSTN call costs incurred from incorrect
set up of you ATA device
Congratulations you are now
ready to start using your
ClubtelCo VoiP serViCe!
