NetComm VELOCITY NP805N User manual

Remote Administration Setup
(NP805n)

Remote Administration:
Remote administration allows you to access the modem / router / VOIP ATA con iguration
page rom a computer connected to the internet.
This can also be used to enable your ISP (Internet Service Provider) to check your settings i
you experience connection issues.
In the case o a VOIP ATA, you would also need to create a “Port Forwarding”
rule on your modem / router or port 80 (or the applicable remote administration
access port) pointing to your VOIP ATA’s IP address.
I your modem / router is a NetComm or Dynalink unit, please see the
appropriate “Port Forwarding” support document or assistance with adding
this rule.
Be ore enabling remote access to your modem, we recommend changing the
username and password required to login.
Please see our “Changing the default username and password” document
or assistance with this.
You can also limit access to a speci ic IP or subnet (*)
This will prevent unauthorised access to your modem.
*
- I supported by your model o modem / router.

This guide will take you through the steps required to enable remote administration access to
your NP805n router.
1. Navigate to http://192.168.20.1 in a web browser.
2. Enter “admin” as both the username and password and press the Login button.

3. Select the Switch to Advanced View option.

5. Enter the IP address, netmask and port number you wish to use or remote
administration.
6. Select the Enable check box to ensure the Remote Administration rule is enabled.
7. Press the Save button to save the new settings to the router.
8. Make sure you have entered a port orwarding rule or the port number you wish to
use on the modem attached to the NP805n router. You should then be able to access
your modem via the address: http://<your external IP address:port number>
You can ind your IP address by going to http://www.whatip.com/.