NetComm CloudMesh User manual

CloudMesh Satellite
NS-02 SEAMLESS WI-FI COVERAGE

2
WHAT
YOU WILL NEED

3
A power point near to where
you want to place
the CloudMesh Satellite
NetComm CloudMesh
Gateway connected
to the Internet
SOURCE CODE - GNU General Public License
This product includes software code that is subject to the GNU General Public License
(“GPL”) or GNU Lesser General Public License (“LGPL”). This code is subject to the
copyrights of one or more authors and is distributed without any warranty.
A copy of this software can be obtained by contacting NetComm.

4
Your CloudMesh Satellite works best when it is
placed in a central location to the area you want
to cover. Ideally, it should be located no more than
two rooms away from the CloudMesh Gateway.

5

6
1
Connect the Power Adapter
to the CloudMesh Satellite.
Ensure that the power switch
is in the ON position.
1
Before you begin, ensure your CloudMesh
Gateway is connected to the Internet.

7
GREEN
Light

8
A solid red light means that the Satellite
needs to be moved closer to the Gateway.
If after ten minutes, the light is still ashing blue,
follow the instructions on the page 14.
Wait ten minutes for the CloudMesh Satellite
to initialise and then check the light status.
A solid white or blue light means the satellite has
been paired with the Gateway and is ready to use.
2

9
Blinking green Powering up
Blinking blue Ready for pairing
Your CloudMesh Satellite light follows this sequence
when rst turned on:
See next page & page 14 for more instructions

10
Solid white Good signal
Solid blue Medium signal
Solid red Poor signal
Blinking blue No signal / too far from gateway / not connected
to mesh network
When connected to the CloudMesh Gateway,
the light shows the signal strength as follows: