Next CLARINGDON 776586 User manual

Tools Needed
All you need to assemble this piece of
furniture is a hammer
(Not supplied)
Helpline
If you have any problems with this product or
require any replacement fittings please contact
Customer Services Tel: [phone]
Regrettably self assembly items cannot be returned once assembly is part or fully completed unless the items
are found to be faulty. Should you need to return the unassembled product, please repack in its original
packaging.
We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step•
instructions.
Carefully check that you have all the parts before beginning assembly.•Keep fittings out of children’s reach and keep children well away from construction area.•We suggest you retain these instructions for future reference.•We recommend that the packaging is used to protect the surfaces during assembly•.A minimum of 2 people are required to assemble this product.•
Assembly Instructions
Please keep these instructions for future reference
Made with solid oak and oak veneer with primer + oil finish.•Natural features ensure that each piece is individual. Every effort is made to ensure colour continuity between•
pieces, however this is a natural product, slight colour variations and natural grain markings may occur.
Oak wood and veneers often have random pale markings in the grain, these are medullary rays which are a•
natural unique feature of this wood
Made in China.•
1 of 7
Important
Product Information
776586 CLARINGDON CORNER DESK

A x 4 B x 8 C x 8 D x 8
8x30mm E x 1 5mmM8x25mm
Avoid exposing the furniture to excessive heat or direct sunlight as this can cause cracking•
of the wood and deterioration of the colour.
Periodically dust lightly with a soft cloth.•Any spills should be removed immediately with a damp cloth.•Do not use silicone based furniture polish.•Ensure that the product is protected with mats & coasters when items are placed on to its surface.•
Never put hot dishes directly onto wooden or glass surfaces as this may mark the furniture.
Wood will mellow and change colour over time, we recommend that ornaments and items placed on•
the surface are moved regularly for the first few months to prevent uneven mellowing.
Take care when moving the furniture and never drag the pieces across the floor, as this will cause•
damage to the joints.
Periodically check fittings are secure and re-tighten as necessary.•Please do not apply Adhesive substrates for example, sticky tape to the product.•
2 of 7
Care Instructions
Fittings

PACK PANELS LIST
1 - 3 1 x 1 2 x 1 x 12 - 3 2 - 3 3
1
2
3
3 of 7
Parts

(Assemble on a flat and even surface)
open the door of chest (2), downward pulling the drawer stoper, then pull out the drawer.•
Insert dowels (A) into chests (2) and (3) with a hammer.•
2
2
3
Ax4
4 of 7
Step One
Step Two

1
2
3
1
23
Ex1
Bx8
Cx8
Dx8
Insert bolts (B), (C) and (D) into chests (2) and (3), tighten with allen key (E).•
Attach top panel (1) to the body of chests (2) and (3).•
5 - 7
Step Three
Step Four

push the drawer into the chest (2).•
1
2
3
6 - 7
Step Five

Hinge adjustment:
Once the product is in required position, doors may need to be aligned as follows:
Laterally (side to side)
Front-to-back
Vertically (up and down)
7 - 7
Step Six