Next L SHELVES User manual

Tools Needed
Helpline
If you have any problems with this product or require
any replacement fittings please contact Customer
Services Tel: [phone]
IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY.
ASSEMBLY INSTRUCTIONS.
Regrettably self assembly items cannot be returned once assembly is part or fully completed unless the item is found
to be faulty. Should you need to return the unassembled product, please repack in the original packaging.
IMPORTANT
• We suggest you spend a short time reading through this leaflet and then follow the simple step-
L SHELVES
by-step instructions.
CARE INSTRUCTIONS
• Made in China
• Avoid keeping furniture in direct sunlight or close to any heat sources as this can cause cracking, discolouration or
warping.
• Carefully check that you have all parts before beginning assembly.
• A minimum of two persons is required to assemble this product.
• All assembly fixings should always be tightened properly and periodically check all fixings and tighten if necessary.
PRODUCT INFORMATION
• We suggest you spend a short time reading through this leaflet and then follow the simple step-
• Keep fittings out of children's reach and keep children well away from the construction area.
• We recommend that the packaging is used to protect the surfaces during assembly.
• Never drag pieces of furniture across the floor as this will cause damage to the joints.
• For general cleaning, periodically dust with a soft cloth.
• Do not use furniture polish.
• Do not rub or scrub the surface when cleaning.
• Any spills should be removed immediately with a soft clean damp cloth and dried immediately.
• Ensure the product is protected with mats and coasters when items are placed on the surfaces, to prevent scratching
or damage.
• Do not put hot dishes directly on the surfaces of the item.
• Made from hollow board, honeycomb board with a wood effect finish.
Page 1 of 4

1.Insert 18× cambolts (D) into panels 1, 2, 3 & 7
with a screwdriver until tight.
STEP ONE
FITTINGS
PARTS
D
AX10 BX1 CX36 DX36 EX36 FX2
1.Glue and insert 1x wooden dowel (A) into panel 7 .
2. Attach panels 3 , 4 & 5 to panel 7.
3. Insert 6 x camlocks (C) into panels 4 ,5 & 7.
Ensure the arrow indicators are pointing towards
the panel edges before tightening with a
screwdriver.
STEP TWO
7
3
1
D
X2
2
3
4
5
B
A
Wide
Page 2 of 4

1.Glue and insert 2x wooden dowels (A) into
panels 3 & 4 .
2. Attach panel 2 to panels 3 , 4 & 5 .
3. Insert 6 x camlocks (C) into panels 3 , 4 & 5.
Ensure the arrow indicators are pointing towards
the panel edges before tightening with a
screwdriver.
1. Attach panel 6 to panel 7 .
2. Insert 2 x camlocks (C) into panel 6.
Ensure the arrow indicators are pointing towards
the panel edges before tightening with a
screwdriver.
STEP THREE
STEP FOUR
5
4
3
2
A
B
C
6
7
C
1.Glue and insert 2x wooden dowels (A) into
panels 3 & 6 .
2. Attach panel 1 to panels 3 & 6 .
3. Insert 4 x camlocks (C) into panels 3 & 6.
Ensure the arrow indicators are pointing towards
the panel edges before tightening with a
screwdriver.
STEP FIVE
3
C
C
AB
3
6
1
Page 3 of 4

1.Use 16 ×stickers (E) to cover the camlock holes
2.Repeat previous steps one to five to assemble the
other product.
1. If you want to stack the two L shelves as the
right diagram, please use screws and
washes provide secure the 2×nylon
stability straps (F) to the top of back panel.
2. Secure the other end of the trap to the wall
with an appropriate screw and wall plug for
your wall type (not provide).
STEP SEVEN
STEP SIX
E
1. If you want to stack the two L shelves as the
right diagram, please use screws and
washes provide secure the 2×nylon
stability straps (F) to the top of back panel.
2. Secure the other end of the trap to the wall
with an appropriate screw and wall plug for
your wall type (not provide).
NB: To hide the strap behind the unit, drill the
hole lower than the top of the unit.
Warning:Always ensure intended wall area
to be drilled is free from hidden electrical
wires, water and gas pipes.
NB: Wall fixings are not included, please source
suitable fixings for your wall type if in doubt,
please consult a qualified tradesperson.
Next Retail Ltd, Desford Road, Enderby, Leicester, LE19 4AT
STEP EIGHT
F
Page 4 of 4