Nienkamper GATEWAY SOFA User manual

Locate slots in the back of the seat (marked in the drawing in red.)
If slot is not cut in the fabric, it will need to be done on site. To do this, press your finger to feel the void in the frame behind the
fabric. Make a 2 1/4” long slit in the fabric with a utility knife.
The screen has 3 mounting locations (shown in red). The two hooks on the top, hook onto a pin that will be revealed once the
fabric is cut in step 1. At the bottom of the screen, there is a metal plate with two 1/4-20 tapped holes. These will be used to
bolt the screen to the black flat bracket on the sofa.
2 1/4”
2 1/4”
bottom mounting bracket
plate with tapped
holes
hook
GATEWAY SOFA
Sofa Screen Installation
Customer Support: 1.800.668.9318
Email: [e-mail]
Web: www.nienkamper.com
Page 1 of 2
THIS IS A GENERAL ASSEMBLY GUIDE, NOT ALL CONDITIONS MAY APPLY TO YOUR
PARTICULAR INSTALLATION.

Align the hook from the screen with the slot in the back of the sofa. You should feel the hook engage with the pin when the
screen is lowered into position.
The plate with tapped holes on the screen should rest on the bottom mounting bracket of the sofa. Attach the screen to the sofa
with two 1/4-20 x 3/4” bolts.
NOTE:
-Install one side first
-Hold onto the one side while installing the
second side.
-While holding both sides bolt to bottom
bracket
*2-3 people required to install.
Customer Support: 1.800.668.9318
Email: [e-mail]
Web: www.nienkamper.com
Page 2 of 2
THIS IS A GENERAL ASSEMBLY GUIDE, NOT ALL CONDITIONS MAY APPLY TO YOUR
PARTICULAR INSTALLATION.