Nienkamper CERN DIVIDER User manual

Customer Support: 1.800.668.9318
Email: [e-mail]
Web: www.nienkamper.com
Page 1 of 2
Lay vertical beams on the ground with slots facing up.
Slide the bottom frame onto the vertical beams.
Lay case on its back so that the metal tabs in the gable align
with the slots in the vertical beam. At this point do not slide
the case down to engage the hooks. Repeat for second
case.
Attach the two remaining vertical beams to the case and the
bottom frame. Slide cases down to engage the hooks in the
vertical beam. It is not a problem if they do not full engage
at while laying down. Once the shelving unit is stood up they
can be tapped with a mallet to engage the hooks.
Slide the top frame onto the vertical beams. Fasten with a
5/16”-18 button head screw.
CERN DIVIDER
INSTALLATION GUIDE
4mm Hex Key
5mm Hex Key
Rubber Mallet
1/2” Crescent Wrench
Level Leveler Glide
5/16”-18 x 1”
Button Head
1/4”-20 x
9/16” Joiner
HARDWARE:TOOLS REQUIRED:
SUGGESTED MINIMUM CREW: 2
APPROXIMATE INSTALL TIME: 1 Hr

Customer Support: 1.800.668.9318
Email: [e-mail]
Web: www.nienkamper.com
Page 2 of 2
THIS IS A GENERAL ASSEMBLY GUIDE, NOT ALL CONDITIONS MAY APPLY TO YOUR
PARTICULAR INSTALLATION.
P/N _________________ 06-9-20
Place bottom shelf in the bottom of the frame. Attach with
¼”-20 x 9/16” joiner bolts.
Stand the entire unit up.
Place a block at the corners of the case and tap with a mal-
let unit the cases are snug and the clips fully engage.