Nienkamper VOX User manual

THIS IS A GENERAL ASSEMBLY GUIDE, NOT ALL CONDITION MAY APPLY TO YOUR PARTICULAR INSTALLATION
Customer Support: 1.800.668.9318
Email: [email protected]om
Web: www.nienkamper.com
With the help of another person, carefully open the frame and
insert blocking pin. This locks the frame into an open position and
is critical to safe assembly.
Assemble lock latch by aligning bottom housings, center pin, lock-
ing pin, lock throw, latch and top housing as shown. Fix housings
to top with #8 x 1”wood screws. Repeat both sides.
Place top sections face down on a protective surface, align through
holes in frame with threaded inserts in top. Secure with M6 button
head screws and washers. Note, slight movement of top and frame
is required for anti-pinch feature. Install plastic cover & x with #6 x
3/8” wood screw.
Apply the instruction / operation decal.
Warning:
Components are sprung and under considerable tension.
To avoid potential injury, always pay close attention during use and installation to the presence of all moving parts.
Nienkamper is not responsible for any damages to property or personal injury due to improper use and or installation.
PAGE 1 OF 2
VOX FOLDING CONFERENCE TABLE
INSTALLATION GUIDE
#4 Hex Key
Philips Screwdriver
Blocking Pin
x 1
Lock Latch
x 2
Operation
Decal
x 1
Plastic Cover
x 4
#6 x 3/8”
Wood Screw
x 4
#8 x 1”
Wood Screw
x 24
Washer
x 12
M6 X 25mm
Button Head
x 12
HARDWARE:
TOOLS REQUIRED:
SUGGESTED MINIMUM CREW: 2
APPROXIMATE INSTALL TIME: 30 min.

THIS IS A GENERAL ASSEMBLY GUIDE, NOT ALL CONDITION MAY APPLY TO YOUR PARTICULAR INSTALLATION
Customer Support: 1.800.668.9318
Email: [email protected]om
Web: www.nienkamper.com
Ensure both lock latches are in the locked position and with the
help of another person, rotate table onto casters. Remove blocking
pin and replace cover cap.
Tuning the atness of the top can be done by rotating the screw as
shown.
OPERATION
OPENING THE TABLE:
Check there are no obstacles around the table and enough space to open it.
The user must stand next to the closed table, facing the tops in symmetrical position.
The user must carefully hold the table tops and slowly distance them, helping the table to open.
While the table opens, the user must guide and hold the table tops with their hands.
When the table is completely opened, the user must lock the latches placed under the table tops.
When the table is in the operative position, the user must lock the casters.
FOLDING THE TABLE:
Check there are no obstacles below the table.
The user must unlock the 4 casters.
The user must unlock the locking latches placed under the table tops.
The user must stand next to the table, facing the point where the tops meet.
The user must spread top section slightly and lift in center, guiding top to vertical position.
The pre-charged spring helps the user in this movement and automatically stops the table at the end of the movement in the closed
position.
The product is not suitable for outdoor use.
PAGE 2 OF 2