Nienkamper METRONOME FLIP TOP User manual

THIS IS A GENERAL ASSEMBLY GUIDE, NOT ALL CONDITION MAY APPLY TO YOUR PARTICULAR INSTALLATION
Customer Support: 1.800.668.9318
Email: [email protected]om
Web: www.nienkamper.com
PAGE 1 OF 2
With the table top upside down on a protective surface, align base
through holes with threaded inserts in top. Be sure to position the
base so the actuator cable and release tab face center inserts.
Fix base assembly in place using 1/4”-20 x 9/16” Joiner Bolts.
Install Shoulder Bolts into center threaded inserts. Be sure to
position the actuator cable behind Shoulder Bolts with Tab facing
out.
Align thru holes in Actuator Cover with pilot holes in top. Position
cover with Actuator Tab sticking out through notch and x with #8
x 5/8” pan head wood screw.
Center inserts
METRONOME FLIP TOP TABLE
INSTALLATION GUIDE
4mm Hex Key
Philips Screwdriver / Bit
Drill Wire
Management
Clip
#8 x 5/8”
Pan Head
Wood Screw
1/4”-20 x 9/16”
Joiner Bolt
HARDWARE:TOOLS REQUIRED:
SUGGESTED MINIMUM CREW: 2
APPROXIMATE INSTALL TIME: 30 min.
Shoulder
Bolt
Ganging Clip &
Thumbscrew
Actuator
Cable Cover
Modesty Stop
Bracket

THIS IS A GENERAL ASSEMBLY GUIDE, NOT ALL CONDITION MAY APPLY TO YOUR PARTICULAR INSTALLATION
Customer Support: 1.800.668.9318
Email: [email protected]om
Web: www.nienkamper.com
PAGE 2 OF 2
Install Power / Connectivity device following the installation docu-
ments included with specic device.
Use #8 x 5/8” pan head wood screws to mount modesty panel.
With table in upright position, tilt Modesty Panel out and remove
protective lm from Velcro tab. Tilt modesty down. This will locate
the tab into the correct position.
Using Wire Management Clips, store and route cables to base along
the rail.
Using #8x 5/8” pan head wood screws mount the Modesty Stop
Bracket.
To unlock and tilt the table top, pull release tab and tilt table down.
To lock into the working position tilt top up and the auto lock will
engage.