Nilfisk-Advance Advenger BR 855 User guide

Nilfisk A/S
Kornmarksvej 1
DK-2605 Brøndby
Denmark
Tel.: [phone]
Fax: [phone]
mail.com@nilfisk.com
www.nilfisk.com
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to
carry out this this procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS
Use and Maintenance
- BR 755/855
ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual
2. Check that the drive pedal is
responding and all circuit breakers
are armed.
1. Check battery charge gauge. 3. Check battery cables are well
connected together.
4. Recovery tank seal cover must
correctly installed and in good
condition.
16. In case something does not work
enter the Service test mode by
pressing the scrub ON switch and the
Vacuum switch together and turn on
the key. Go through the menu.
13. Make sure that deck and squeegee
are moving down when pressing
the button.
11. Install Brushes. 12. Adjust side skirts height 14. Adjust water flow. 15. Adjust detergent flow.
7. Check the height of the squeegee by
adjusting the castor wheels.
5. Inspect the squeegee blades for cuts
or chunks.
6. Install squeegee. 8. Open broom door compartment
and check presence of ropes or
debris that can block it.
9. Check presence of water in the
solution tank.
10. If necessary open the solution filter
cage and clean the net.

Nilfisk A/S
Kornmarksvej 1
DK-2605 Brøndby
Denmark
Tel.: [phone]
Fax: [phone]
mail.com@nilfisk.com
www.nilfisk.com
The machine
doesn’t work
as it should?
The suction
doesn’t work
as it should?
The machine
doesn’t clean
as it should?
The brush
don’t work as they
should?
Troubleshooting
- BR 755/855
ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual
1Check battery charge gauge.
1Check if the suction hose is
correctly installed and cleaned.
1Check if you have the right water
settings.
1Check if the brush are correctly in-
stalled and not worn out.
2Check that the drive pedal is re-
sponding and all circuit breakers are
armed.
2Open the recovery tank and check
if the vacuum grid and gasket are
cleaned.
2Check if the solution tap is open.
2Check if there isn’t any brush motor
overload i.e. 3 battery Ledsflash si-
multaneously.
3Check if squeegee blades are
damaged or dirty.
3Check if there are external materials
avoiding brush rotating.
4Close the recovery tank cover prop-
erly and/or verify the gasket wear.
3Check if the solution filter is
cleaned.
3Check battery cables are well con-
nected together.
4Recovery tank seal cover must
correctly installed and in good
condition.