
CUSTOMER CARE - AU: 1800 890 840 2
9 DO NOT use with damaged cord or plug.
Contact Customer Service or Service Center
for the repair or replacement of the line cord.
10 DO NOT USE if the appliance is not working,
has been dropped, dropped into water,
damaged or left outdoors.
11 NO SERVICEABLE PARTS. Incorrect
re-assembly or repair can cause a risk of
electrical shock or injury to persons when
the appliance is used. Contact Customer
Service or Service Center for the repair or
replacement under the warranty agreement.
12 If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
13 DO NOT let the power cord hang over
the edge of table or counter or touch hot
surfaces such as the stove.
14 Always use the appliance on a dry, level
surface.
15 Keep hands, hair, clothing, as well as utensils
out of container while processing or blending
to reduce the risk of severe injury to persons
or damage to the appliance. A scraper may
be used but only when the appliance is not
running.
16 Avoid contact with moving parts.
17 DO NOT remove the Power Pod before the
blades have stopped turning.
18 DO NOT attempt to sharpen blades.
19 DO NOT use the appliance if the blades are
bent or damaged.
20 DO NOT block the vents on the Power Pod
when using the appliance.
21 DO NOT operate this appliance on or near
any hot surfaces (such as gas or electric
burner or in a heated oven).
22 The use of attachments or accessories
including canning jars, not recommended by
the manufacturer may result in fire, electric
shock or personal injury.
23 To avoid injury, never attempt to place the
single serve blade assembly onto the Power
Pod without first assembling the blade
assembly to the Nutri Ninja®cup.
24 When using the blades, make sure they
are properly installed before operating the
appliance.
25 Extreme caution must be used when moving
an appliance containing hot food, water or
other liquids.
26 DO NOT expose containers to extreme
temperature changes.
27 DO NOT overfill. DO NOT exceed max fill
line.
28 DO NOT operate the appliance empty.
29 To reduce the risk of burns, always allow the
appliance to cool before taking off parts and
before cleaning.
30 Max ON time is 30 seconds under 700W
load. If the appliance overheats, a thermal
switch will become activated and shut off the
motor. To reset, unplug the appliance and let
it cool down for approximately 15 minutes
before using again.
31 THIS PRODUCT IS INTENDED FOR
HOUSEHOLD USE ONLY. Do not use this
appliance for anything other than its intended
use. Do not use outdoors.
SAVE THESE
INSTRUCTIONS