Nitek EL4500U User manual

Model EL4500U(for use with Network cable)
Includes one ET4500U Transmitter
and one ER1500U Receiver
Installation and
Operation Manual
Introduction
The EL4500U system uses a four channel transmitter and a single channel receiver to extend Ethernet & PoE. The
EL4500U can be used on new or existing cable and is designed to greatly extend the distances to which IP cameras and
network devices can operate. In addition to network communication the EL4500U is ideal for PoE applications. It allows
all power to flow from the head end for most camera applications. In unique cases where high power PoE is needed it
can inject up to 25 watts of power at the transmitter end.
NITEK®
De Aar 99
8253 PN Dronten
The Netherlands
Tel: [phone]
E-mail: [email protected]
WWW.NITEK.NET
USA
5410 Newport Drive, # 24
Rolling Meadows, IL 60008
Phone: [phone]
Fax: [phone]
E-mail: [email protected]
WWW.NITEK.NET
EUROPE
05122014
TYPE 1 Installation
Install EL4500U with a PoE Source Switch and IP Cameras
Refer to the diagram below when installing. A common hookup involves a length of network cable up to 2,000ft / 600m,
the EL4500U transmitter and receiver pairs (ET4500U & ER1500U), an IP camera or other peripheral network device
(both universally referred to as the Power Device or PD), and a 3rd party PoE network switch or Power Sourcing
Equipment/PSE.
To hook up the EL4500U begin by connecting the ER1500U to the Power Sourcing Equipment, usually a switch (RJ45-
to-RJ45) via a CAT5/CAT6 patch cable. Next connect the ER1500U “Link Port” to category cable running from the
ER1500U to the ET4500U. The IP cameras interface with the ET4500C via RJ45 and a CAT5/CAT6 patch cords. Power
for the IP Cameras is provides from the PS48 power supply connected to the ET4500U.
Note: This installation should be made by a
qualified service person and conform with local
codes.
Reduce risk of fire or electrical shock. Do not
expose this product to rain or moisture.
RoHS
COMPLIANT
2002/95/EC
Patent Pending
IP Camera
IP Camera
IP Camera
48Vdc @ 1Amp
Power Supply
ER1500U
600m
2000ft
Receiver
NITEK
Link
Port
NITEK
RoHS
COMPLIANT
ET4500U
Transmitter
Link
Port
DC
Input
IP
Port 4
IP
Port 3
IP
Port 2
IP
Port 1
PoE
Switch
Common Network Cable
Connec-
tor LED OFF ON FLASHING
Network
Port
PoE Out No PoE
Power Out PoE Power Good
Link Status No Ethernet
Link Ethernet Link Good
Link
Port
Power No Power Power
Good
10/100 No Link 100Mb 10Mb
LED INDICATORS