niu M1 Sport User manual

USER MANUAL

CONTENTS
General Notice
Precautions
Safety Notice
Download APP and Register
Rapid Installation
Parts Info
Operation Guide
Battery Use and Maintenance
DOs and DON'Ts while Riding
Maintenance and Repair
Troubleshooting List
Technical Parameters
Maintenance Record
·····································2
········································3
·······································4
························6
···································8
·········································10
··································15
·····················22
·····················28
··························30
·······························34
·····························41
······························46

2
General Notice
Please read this User Manual carefully for proper operation before riding the scooter.
For your safety, please check whether the parts are in good condition according to this User
Manual before riding. Contact your dealer in time in case of any problems.
Please follow the traffic laws. Slow down on slippery roads in bad weather to allow greater
braking distance for your safety.
Please pay attention to deep water. It may cause rusting or failure of the motor, battery or
other parts if water level reaches wheel axle.
Do not dismantle the scooter on your own. Please contact your dealer for replacement or
purchase of original parts.
Do not lend your M1 to those who can’t operate a scooter for others' safety and preventing
unnecessary damage to your scooter.
Please keep this User Manual properly.

Precautions
Rider and Passenger
M1 is not designed for a ride of more than 2 persons.
Riding Conditions
M1 is not designed for off-road use.
This User Manual should be deemed as a permanent document of M1. If this scooter is
transferred to others, this User Manual should also be handed over to the new owner.
Reproduction or reprint of any part of this User Manual is strictly prohibited.
Warning: Failure to follow the instructions herein may lead to serious casualties.
3
Attention: Failure to follow the instructions herein may lead to personal injury or scooter
damage.

Safety Notice
Using a safety helmet and protective goggles is strongly advised.
You are advised to take proper training or exercise before using on open roads.
Please follow the Operation Guide (P.15) to fully understand how to properly operate the
scooter.
It should be noted that the braking distance in bad weather will be much longer. Please
avoid braking on paint markers, manhole covers and oil stains to prevent slipping. Pay extra
attention when riding through railway crossings, junctions, tunnels, and bridges. Slow down
if road conditions are unclear.
4

Do not use high beam indiscriminately. Continuous use of high beam may disturb the vision
of the drivers and pedestrians.
Do not use mobile phones or other electronic devices which may draw your attention while
riding.
Do not change the lane without signaling. Changing the lane at will is one of the major
causes for accidents. When you need to change the lane, remember to switch on the Turn
Signal Indicator first. Always check the vehicles approaching from behind before changing
the lane.
5

Download APP and Register
Scan the QR code below to download the APP titled NIU Scooter.
Run Setup after downloading and register.
1
2
6

Attach the
SN Code here Note:
The mobile phone system is required
to be at least Android 4.0 or iOS 8.
Make sure that the mobile phone has
been connected to the Internet when
running NIU app (Wi-Fi/2G/3G/4G).
Scan the QR code below for scooter binding after registration.
3
7

Rapid Installation
Open the Accessories Box to take the tools
Align the windshield rubber part with the windshield holes and then install it.
Tighten the two screws with a screwdriver to secure the windshield.
1
2
3
8

Install the rearview mirrors into the mounting holes on dashboard and turn it
clockwise. The bolt shall be screwed in for more than 15mm.
Adjust the rearview mirror to an appropriate position and then tighten nuts on the
rearview mirror with a spanner. Properly set the dust cover.
4
5
9

Parts Info
Handrail
Reflector
Headlight
Right
Combination
Switch
Turn Signal
Indicator
10

Parts Info
Windshield
Taillight
Rearview
Mirror
Left
Combination
Switch
Side
Stand
Saddle
11

Ready Indicator
Economic Mode
Energy Recycling
Cruising Mode
Battery Bar
Fault Code
Speed
Distance Travelled
Battery Percentage&
Remaining Charging Time
Charging
Percentage
High Beam
Low Battery Indicator
Left Turn
Signal Indicator
Time
Charging
Riding
Mode
Right Turn
Signal Indicator
Dashboard Display Info
12

Left Turn Signal Indicator
Right Turn Signal Indicator
High Beam
Ready Indicator
Low Battery Indicator
Time
Economic Mode
Energy Recycling Status
Riding Mode
Dashboard Display Info
The Left Turn Signal Indicator is on.
The Right Turn Signal Indicator is on.
The High Beam is on.
In riding Mode.
Battery level less than 20%.
Now is 12:00 pm.
Ideal energy consumption status.
Energy is being recycled from braking.
Mode 2 is selected.
13

Dashboard Display Info
Speed
Charging Percentage (Large)
Battery Bar
Battery Percentage (Small)
Remaining Charging Time
Charging
Distance Travelled
Current speed is 26km/h.
Current battery charging progress is 13%.
Current battery level.
E: Low battery (less than 10%)
F: Full battery (more than 90%)
Battery level in percentage is 89%.
The remaining charging time is 3.2 hours.
The battery is being charged.
Distance Travelled is 802km.
14

Operation Guide
USB Port
Keyhole Light
Hook
Keyhole
15

Off
On
Open Saddle Turn on
the Scooter Push the key in and turn to LOCK
position to lock the
Steering Handlebar
Open
Saddle
Lock
Steering
Handlebar
Operation Guide
Locating Button
Unlock Button
Lock Button
Remote Controller Key
16

Operation Guide
Start the Scooter
Press the Unlock button of the remote controller. After the Turn Signal Indicators flash
twice, the scooter is unlocked. Insert the key into the Keyhole and turn to . Press and
hold the Start Button for 2 seconds, on Dashboard will light on. You are ready to go.
Locking the scooter
Turn the key to to turn off the scooter. Turn the steering handlebar to the left, then
push the key inward and turn to LOCK to lock Steering Handlebar. Press the Lock Button
on the Remote Controller within an effective distance to turn on the Alarm. The Turn Signal
Indicators will stay on for 2 seconds after the scooter is properly locked.
Locating
Press the Locating Button and the Turn Signal Indicators will flash for 10 seconds. If no
further operation during this period, the Alarm will be on for 10 seconds. The Alarm can be
cancelled by pressing the Unlock or Lock Button.
17

High/Low Beam Light
Turn Signal Indicator
Horn
Cruising Mode
Operation Guide
18