luminii Katana KAT User manual

REV2.4
Katana - Installation Instructions
Model KAT-
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS & INSTRUCTIONS WITHOUT NOTICE
1. PRODUCT TO BE INSTALLED BY A
QUALIFIED ELECTRICIAN
2. USE ONLY WITH CLASS 2 POWER UNIT
3. 24 VOLTS DC
4. SUITABLE FOR DAMP LOCATIONS
5. SURFACE MOUNT ONLY
6. SUITABLE FOR INSTALLATION WITHIN THE
CLOSET STORAGE SPACE
7. TYPE IC
8. INHERENTLY PROTECTED
Please read all instructions prior to installation and keep for future reference!
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
Page 1 of 2
12
Katana light fixture body
Use the dimensions above for reference, when mounting to the
surface.
2.06”
0.31”
0.66” 0.70” 0.70”
mounting
brackets
mounting
screws
wires to
power
supply
Align the fixture to the determine location,
(low voltage power wires must be present prior to
installing). Secure by tightening the two screw
through the mounting brackets to the drywall.
Ensure power is off to power supply!
Then proceed to connect wires from Katana light fixture to
power supply. Connection can be established with lead wires or
quick-connect powerfeed. For more information please refer to
power supply wiring instructions.
power to Katana
light fixture
24VDC class II
power supply
120VAC line
voltage wires
24VDC low
voltage wires
3
lens
Remove the protective film from the diffuser lens.
film
4

REV2.4
Katana - Installation Instructions
Model KAT-
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS & INSTRUCTIONS WITHOUT NOTICE
1. PRODUCT TO BE INSTALLED BY A
QUALIFIED ELECTRICIAN
2. USE ONLY WITH CLASS 2 POWER UNIT
3. 24 VOLTS DC
4. SUITABLE FOR DAMP LOCATIONS
5. SURFACE MOUNT ONLY
6. SUITABLE FOR INSTALLATION WITHIN THE
CLOSET STORAGE SPACE
7. TYPE IC
8. INHERENTLY PROTECTED
Please read all instructions prior to installation and keep for future reference!
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
Page 2 of 2
power supplies at the
end of the run
power supplies in the
middle of the run
consecutive layout,
NOT RECOMMENDED
multiple powerfeed layouts
power supply
low voltage wires
fixture 1
fixture 1 fixture 2
low voltage wires
power supply
power supply
low voltage wires
fixture 1
power supply
low voltage wires
fixture 2