Nokia Asha 500 Dual SIM RM 972 User manual

Check the repair
policy before
performing any
mechanical repair
on Service Level
1&2!
Service Manual for L1 an
d
L
2
Nokia Asha 500 Dual SIM
RM-934, RM-97
2
Nokia Asha 500
RM-973
Key features
z
2.8" QVGA Display
z
Capacitive touch screen and back key
z
2 MP Camera
z
Wi-Fi support
z
Micro SD card support up to 32 GB
Version 1.0
Exploded view Disassembly steps Assembly hints
Solder components Service devices Product controls and interfaces
Service concept
©2013 Nokia | Nokia Internal Use only | All Rights Reserved.
More More More
More More More
More

Service Manual Level 1 and 2
Nokia Asha 500 Dual SIM, Nokia Asha 500
RM-934 RM-972 (Dual SIM), RM-973 (Single SIM)
Version 1.0
Exploded view
EARPIECE GASKET
I0004
RELEASE BUTTON
I0022
A-COVER
I0001
EARPIECE
I0003
DISPLAY
I0014
LIGHT SWAP PWB
I0008
CAMERA
I0006
D-COVER
I0020
BT ANTENNA
I0018
SIM LID
I0019
TYPE LABEL
I0013
TOUCH IC GASKET
I0007
TOUCH PANEL
I0002
DISPLAY CONDUCTIVE
ADHESIVE
I0012
TOUCH WINDOW
PROTECTIVE TAPE
I0005
IHF SPEAKER
I0015
SPEAKER MESH
I0017
SPEAKER BOTTOM GASKET
I0016
GSM ANTENNA MODULE
I0021
B-COVER
I0024
BB SHIELDING LID
I0009
RF SHIELDING LID
I0010
WLAN SHIELDING LID
I0011
SCREW TORX+ SIZE 6
M1.6 x 4.3
I0023
LIGHT SWAP PACKAGE
(I0006 - I0013)
2
D-COVER ASSEMBLY
(I0016 - I0020)
3
A-COVER ASSEMBLY
(I0001 - I0005)
1
Only available
as assembly
Not reuseable
after removal
Repair/swap
only in level 3
©2013 Nokia | Nokia Internal Use only | All Rights Reserved.

Service Manual Level 1 and 2
Nokia Asha 500 Dual SIM, Nokia Asha 500
RM-934 RM-972 (Dual SIM), RM-973 (Single SIM)
Version 1.0
Disassembly steps
1) For disassembling you need the Nokia Standard toolkit version 2. You will also need the camera
removal tool SS-276.
2) Protect the TOUCH PANEL with protective film.

3) Push from the RELEASE BUTTON to release the B-COVER.
4) Remove the B-COVER.

5) Unscrew the four Torx+ size 6 screws in the order shown.
6) Start releasing the D-COVER from the top left corner with the SRT-6 to detach the two shown clips.

7) Then release the other clip on the left side of the device.
8) Then release the two clips on the right side of the device

9) Remove the D-COVER.
10) Open the DISPLAY connector. Be careful not to damage the connector or any components nearby.

11) To remove the ENGINE BOARD, first release the shown clip with the SRT-6.
12) Then release the other shown clip with the SRT-6.

13) Remove the ENGINE BOARD.
14) Protect the DISPLAY with protective film.

15) Release the DISPLAY by carefully sliding the SS-93 under it to detach the adhesive.
16) Remove the DISPLAY.