5
Switch the device on
1Press and hold .
2If the device asks for a (U)PIN code or
lock code, enter the code (displayed as
****), and press the left selection key.
The UPIN code is usually supplied with
the USIM card. The factory setting for
the lock code is 12345. For more
information on the access codes, see
‘Security’ in the user guide.
Your device has internal antennas.
Note: As with any radio
transmitting device, avoid touching an
antenna unnecessarily when the
antenna is in use. For example, avoid
touching the cellular antenna during a
phone call. Contact with a
transmitting or receiving antenna
affects the quality of the radio
communication, may cause the device
to operate at a higher power level than
otherwise needed, and may reduce the
battery life.
Charge the battery
1Connect a compatible charger to
a wall outlet.
2Connect the power cord to the
device. The device can be used
while charging. If the battery is
completely discharged, it may
take a while before the charging
indicator starts scrolling.
3When the battery is fully charged, the charging indicator
stops scrolling. Disconnect the charger from the device, then
from the wall outlet.
You can also use Nokia Charger Adapter CA-44 to charge the
battery with previous compatible Nokia charger models. For
enhancements, batteries, and chargers, see ‘For your safety’ in
the user guide.
MMS and mobile internet settings
Your Nokia device normally has MMS, GPRS, streaming, and
mobile internet settings automatically configured in the device,
based on your service provider information.
GundamS_GS_SGML.book Page 5 Tuesday, November 7, 2006 1:03 PM