Nokia X1-00 User manual

Nokia X1-00 User Guide
Issue 1.0

Contents
Safety 3
Get started 4
Insert the SIM card and battery 4
Insert or remove a memory card 5
Charge the battery 6
Antenna 7
Switch on or off 7
Your phone 7
Keys and parts 7
Make a call 8
Text input 9
Message 10
Save a name and phone number 10
Save numbers in five separate
phonebooks 11
Listen to music 11
FM Radio 12
Flashlight 13
Support 13
Nokia original accessories 14
Practical rules about accessories 14
Battery 14
Product and safety information 15
Index 20
2Contents

Safety
Read these simple guidelines. Not following them may be dangerous or illegal. Read
the complete user guide for further information.
SWITCH OFF IN RESTRICTED AREAS
Switch the device off when mobile phone use is not allowed or when it may
cause interference or danger, for example, in aircraft, near medical
equipment, fuel, chemicals, or blasting areas.
ROAD SAFETY COMES FIRST
Obey all local laws. Always keep your hands free to operate the vehicle while
driving. Your first consideration while driving should be road safety.
INTERFERENCE
All wireless devices may be susceptible to interference, which could affect
performance.
QUALIFIED SERVICE
Only qualified personnel may install or repair this product.
BATTERIES AND OTHER ACCESSORIES
Use only batteries, chargers and other accessories approved by Nokia for use
with this device. Do not connect incompatible products.
KEEP YOUR DEVICE DRY
Your device is not water-resistant. Keep it dry.
PROTECT YOUR HEARING
Listen to a headset at a moderate level, and do not hold the device near your
ear when the loudspeaker is in use.
Safety 3

Get started
Insert the SIM card and battery
Important: Do not use a mini-UICC SIM card, also known as a micro-SIM card, a
micro-SIM card with an adapter, or a SIM card that has a mini-UICC cutout (see figure)
in this device. A micro SIM card is smaller than the standard SIM card. This device does
not support the use of micro-SIM cards and use of incompatible SIM cards may damage
the card or the device, and may corrupt data stored on the card.
The SIM card and its contacts can be easily damaged by scratches or bending, so be
careful when handling, inserting, or removing the card.
1 Place your finger in the recess at the bottom of the device, and carefully lift and
remove the back cover (1).
2 If the battery is inserted, lift the battery out (2).
3 Open the SIM card holder (3). Make sure the contact area is facing down, and insert
the SIM card (4). Close the holder.
4 Line up the contacts of the battery and the battery compartment, and insert the
battery (5). To replace the back cover, direct the top locking catches toward their
slots (6), and press down until the cover locks into place (7).
4Getstarted

This phone is intended for use with the BL-5J battery.
Insert or remove a memory card
Use only compatible memory cards approved by Nokia for use with this device.
Incompatible cards may damage the card and the device and corrupt data stored on the
card.
Memory cards may be available separately.
Your device supports microSD cards with a capacity of up to 16 GB.
Insert a memory card
1 Open the cover of the memory card slot.
2 Insert the memory card. Push the card in, until it locks into place. Make sure the
contact area is facing up.
3 Close the slot cover.
You can remove or replace the memory card without switching the device off.
Get started 5

Remove the memory card
Important: Do not remove the memory card when an application is using it.
Doing so may damage the memory card and the device, and corrupt data stored on the
card.
1 Open the cover of the memory card slot.
2 Push the card in gently, until it is released, and pull the card out.
3 Close the slot cover.
Charge the battery
Your battery has been partially charged at the factory, but you may need to recharge it
before you can switch on your device for the first time.
If the device indicates a low charge, do the following:
1 Connect the charger to a wall outlet.
2 Connect the charger to the device.
3 When the device indicates a full charge, disconnect the charger from the device,
then from the wall outlet.
Tip: To save energy, unplug the charger when the battery is fully charged.
You do not need to charge the battery for a specific length of time, and you can use the
device while it is charging.
If the battery is completely discharged, it may take several minutes before the charging
indicator appears on the display or before any calls can be made.
If the battery has not been used for a long time, to begin charging, you may need to
connect the charger, then disconnect and reconnect it.
It may take longer than expected before the device is fully charged, due to the large
capacity of the BL-5J battery.
6Getstarted

Antenna
The antenna area is marked in grey.
Avoid touching the antenna area unnecessarily while the antenna is transmitting or
receiving. Contact with antennas affects the communication quality and may cause a
higher power level during operation and may reduce the battery life.
Switch on or off
Press and hold the end key.
Your phone
Keys and parts
1End/Power key
Your phone 7

2Earpiece
3Display
4Selection keys
5Navi™ key (scroll key)
6Call key
7Keypad
8Microphone
9Wrist strap hole
10 Music keys
11 Charger connector
12 Flashlight
13 Headset connector/Nokia AV Connector (3.5 mm)
14 Memory card slot
15 Loudspeaker
Make a call
1 Enter the phone number, including the country code and area code, if necessary.
2 Press the call key.
3 To end the call, press the end key.
8 Your phone

Use the loudspeaker or earpiece
During a call, select Loudsp. or Hands..
Change the volume
During a call, scroll left or right.
Text input
Write text
To enter text, you can use traditional or predictive text input. Not all languages are
supported by predictive text input.
Use traditional text input
Press a key repeatedly until the desired letter is displayed.
Activate predictive text input
Select Options > Dictionary and the desired language.
Deactivate predictive text input
Select Options > Dictionary > Dictionary off.
When using predictive text input, press each key once for a single letter. If the desired
word is displayed, press 0, and start writing the next word. If ? is displayed after the
word, the word is not in the dictionary.
Change a word
Press *repeatedly until the desired word is displayed.
Add a word
Select Spell, enter the word using traditional text input, and select OK.
Add a space
Press 0.
Change text input method
Press #repeatedly, and check the indicator at the top of the display.
Add a number
Press and hold the desired number key.
Add a special character
Press *when using traditional text input; press and hold *when using predictive text
input.
Your phone 9

Clear a whole message
Select Options > Clear text.
You can undo the clearing of a whole message, but only right after you have selected
Clear text.
Undo clearing of a whole message
Select Options > Undo clear.
Message
The message services can only be used if they are supported by your service provider.
You can send text messages that are longer than the character limit for a single message.
Longer messages are sent as two or more messages. Your service provider may charge
accordingly.
Characters with accents, other marks, or some language options, take more space, and
limit the number of characters that can be sent in a single message.
Write and send a message
1 Select Menu > Messages > Create message.
2 Write the message. The message length indicator shows how many characters you
can enter in the message.
3 Select Options > Send, enter the recipient's phone number or select it from the
contacts list, and select OK.
Delete messages
Select Menu > Messages > Delete messages > All read or the desired folder.
Save a name and phone number
You can save names and phone numbers on the SIM card and in the phone memory. Up
to 500 contacts can be stored in the phone memory.
Select Menu > Contacts.
1 Select Add contact.
2 Enter the name and phone number.
You can also select a picture for the contact.
Set where to save new contacts
Select Settings > Memory in use and the desired location.
10 Your phone