Nokia BH-606 User manual

Nokia Bluetooth Headset BH-606
Issue 1.1
12
9
11
2
3
4
78
5
1
10
6

2
2© 2008 Nokia. All rights reserved.
DECLARATION OF CONFORMITY
Hereby, NOKIA CORPORATION declares
that this HS-128W product is in
compliance with the essential
requirements and other relevant
provisions of Directive 1999/5/EC. A
copy of the Declaration of Conformity
can be found at http://www.nokia.com/
phones/declaration_of_conformity/.
© 2008 Nokia. All rights reserved.
Nokia, Nokia Connecting People and the
Nokia Original Accessories logo are
trademarks or registered trademarks of
Nokia Corporation. Other product and
company names mentioned herein may
be trademarks or tradenames of their
respective owners.
Reproduction, transfer, distribution, or
storage of part or all of the contents in
this document in any form without the
prior written permission of Nokia is
prohibited.
Bluetooth is a registered trademark of
Bluetooth SIG, Inc.
Nokia operates a policy of ongoing
development. Nokia reserves the right to
make changes and improvements to any
of the products described in this
document without prior notice.
To the maximum extent permitted by
applicable law, under no circumstances
shall Nokia or any of its licensors be
responsible for any loss of data or
income or any special, incidental,
consequential or indirect damages
howsoever caused.
The contents of this document are
provided "as is". Except as required by
applicable law, no warranties of any
kind, either express or implied,
including, but not limited to, the implied
warranties of merchantability and
fitness for a particular purpose, are
made in relation to the accuracy,
reliability or contents of this document.
Nokia reserves the right to revise this
document or withdraw it at any time
without prior notice.
The availability of particular products
may vary by region. Please check with
your Nokia dealer for details.

© 2008 Nokia. All rights reserved. 3
Export controls
This device may contain commodities,
technology or software subject to export
laws and regulations from the US and
other countries. Diversion contrary to
law is prohibited.
Introduction
With the Nokia Bluetooth Headset
BH-606, you can make and receive
calls while on the move.
Read this user guide carefully
before using the headset. Also,
read the user guide for your phone.
This product may contain small
parts. Keep them out of the reach
of small children.
Bluetooth wireless
technology
Bluetooth wireless technology
allows you to connect compatible
devices without cables. The phone
and the headset do not need to be
in line of sight, but they should be
within 10 metres (33 feet) of each
other. Connections may be subject
to interference from obstructions,
such as walls, or other electronic
devices.
The headset is compliant with the
Bluetooth Specification 2.0 + EDR
supporting the Headset Profile 1.1
and Hands-Free Profile 1.5. Check
with the manufacturers of other
devices to determine their
compatibility with this device.

4
4© 2008 Nokia. All rights reserved.
Get started
The headset contains the
following parts shown on the title
page: white indicator light (1),
earloop (2), volume key (3), power
key (4), answer/end key (5),
earpiece (6), charger connector
(7), and microphone (8).
Before using the headset, you
must charge the battery and pair
the headset with a compatible
phone.
Parts of the device are magnetic.
Metallic materials may be
attracted to the device. Do not
place credit cards or other
magnetic storage media near the
device, because information
stored on them may be erased.
Charge the battery
Before charging the battery,
carefully read “Battery and
charger information”.
Warning: Use only
chargers approved by
Nokia for use with this
particular model. The use
of any other types may
invalidate any approval or
warranty, and may be
dangerous.
When you disconnect the power
cord of any accessory, grasp and
pull the plug, not the cord.
1. Connect the charger to a wall
outlet.
2. Connect the charger cable to
the charger connector. During
charging, the indicator light is
on and the headset cannot be

© 2008 Nokia. All rights reserved. 5
used. Charging the battery fully
may take up to 2 hours.
3. When the battery is fully
charged, the indicator light
turns off. Disconnect the
charger from the headset, then
from the wall outlet.
If the headset was connected
to your phone before charging,
the headset connects to it
again.
The fully charged battery has
power for up to 8 hours of talk
time or up to 280 hours of standby
time.
When the battery is discharged,
the headset beeps every minute
and the indicator light flashes
quickly.
Switch on or off
To switch on, press and hold the
power key for about 2 seconds. The
headset beeps, and the indicator
light is displayed. The headset tries
to connect to a paired phone.
To switch off, press and hold the
power key for about 2 seconds. The
headset beeps, and the indicator
light turns off.
Pair the headset
1. Ensure that your phone is on
and the headset is off.
2. Press and hold the power key
(for about 5 seconds) until the
indicator light starts to flash
quickly.
3. Activate the Bluetooth feature
on the phone, and set it to
search for Bluetooth devices.
4. Select the headset from the list
of found devices.
5. Enter the passcode 0000 to
pair and connect the headset to
your phone. In some phones,

6
6© 2008 Nokia. All rights reserved.
you may need to make the
connection separately after
pairing.
When the headset is connected to
your phone and is ready for use,
the indicator light flashes about
every 5 seconds.
Basic use
Place the headset on the ear
Slide the earloop behind your ear,
and point the headset toward your
mouth (9 and 10). Gently push the
earpiece into your ear. To use the
headset on the left ear, detach the
earloop (11), flip it, and push it
into place (12).
Calls
To make a call, use your phone in
the normal way when the headset
is connected to it.
To redial the number you last
called (if your phone supports this
feature with the headset), when
no call is in progress, press the
answer/end key twice.
To activate voice dialling (if your
phone supports this feature with
the headset), when no call is in
progress, press and hold the
answer/end key for about 2
seconds. Proceed as described in
the phone user guide.
To answer or end a call, press the
answer/end key. To reject a call,
press this key twice.
To set the headset volume, slide
the volume key up or down.

© 2008 Nokia. All rights reserved. 7
To mute or unmute the
microphone during a call, press
the middle of the volume key.
To switch a call between the
headset and a compatible phone,
press and hold the answer/end key
(or the power key) for about 2
seconds.
Handle two calls
To answer a waiting call and put
the active call on hold, press and
hold the answer/end key for about
2 seconds.
To answer a waiting call and end
the active call, press the answer/
end key.
To end the active call and activate
the call on hold, press the answer/
end key.
To switch between the active call
and the call on hold, press and
hold the answer/end key for about
2 seconds.
To use these features, your phone
must support the Bluetooth
Hands-Free profile 1.5, and call
waiting (network service) must be
activated in the phone.
Clear settings or reset
To delete the pairings from the
headset, switch off the headset,
and press and hold the power key
and the answer/end key for about
5 seconds.
To reset the headset if it stops
functioning, even though it is
charged, connect the headset to a
charger that is connected to a wall
outlet.
Troubleshooting
If you cannot connect the headset
to your compatible phone, check
that the headset is charged,

8
8© 2008 Nokia. All rights reserved.
switched on, and paired with the
phone.
Battery and charger information
This device has an internal,
nonremovable, rechargeable battery.
Do not attempt to remove the battery
from the device as you may damage
the device. This device is intended for
use when supplied with power from
the following chargers: AC-3, AC-4,
AC-5, and DC-4. The exact charger
model number may vary depending
on the type of plug. The plug variant
is identified by one of the following:
E, EB, X, AR, U, A, C, or UB. The battery
can be charged and discharged
hundreds of times, but it will
eventually wear out. Recharge your
battery only with Nokia approved
chargers designated for this device.
Use of an unapproved charger may
present a risk of fire, explosion,
leakage, or other hazard.
If a battery is being used for the first
time or if the battery has not been
used for a prolonged period, it may be
necessary to connect the charger,
then disconnect and reconnect it to
begin charging the battery. If the
battery is completely discharged, it
may take several minutes before the
charging indicator light is displayed.
Unplug the charger from the
electrical plug and the device when
not in use. Do not leave a fully
charged battery connected to a
charger, since overcharging may
shorten its lifetime. If left unused, a
fully charged battery will lose its
charge over time.
Always try to keep the battery
between 15°C and 25°C (59°F and
77°F). Extreme temperatures reduce

© 2008 Nokia. All rights reserved. 9
the capacity and lifetime of the
battery. A device with a hot or cold
battery may not work temporarily.
Battery performance is particularly
limited in temperatures well below
freezing.
Do not dispose of batteries in a fire as
they may explode. Batteries may also
explode if damaged.
Never use any charger that is
damaged.
Important: Battery talk
and standby times are
estimates only and
depend on network
conditions, features used,
battery age and
condition, temperatures
to which battery is
exposed, and many other
factors. The amount of
time a device is used for
calls will affect its
standby time. Likewise,
the amount of time that
the device is turned on
and in the standby mode
will affect its talk time.

10
10 © 2008 Nokia. All rights reserved.
Care and maintenance
Your device is a product of superior
design and craftsmanship and should
be treated with care. The following
suggestions will help you protect
your warranty coverage.
• Keep the device dry. Precipitation,
humidity, and all types of liquids
or moisture can contain minerals
that will corrode electronic
circuits. If your device does get
wet, allow it to dry completely.
• Do not use or store the device in
dusty, dirty areas. Its moving parts
and electronic components can
be damaged.
• Do not store the device in hot
areas. High temperatures can
shorten the life of electronic
devices, damage batteries, and
warp or melt certain plastics.
• Do not store the device in cold
areas. When the device returns to
its normal temperature, moisture
can form inside the device and
damage electronic circuit boards.
• Do not attempt to open the
device.
• Do not drop, knock, or shake the
device. Rough handling can break
internal circuit boards and fine
mechanics.
• Do not use harsh chemicals,
cleaning solvents, or strong
detergents to clean the device.
• Do not paint the device. Paint can
clog the moving parts and prevent
proper operation.
These suggestions apply equally to
your device, charger, or any
accessory. If any device is not
working properly, take it to the
nearest authorised service facility for
service.