Cautions
•We recommend this dispenser cleaning procedure to be done after daily use.
•Be careful not to scratch or damage the parts, and use soft towel to dry.
•Be careful not to lose O-rings in Nozzles, and do not apply too much force while assembling.
•Be careful not to make water overflow from ReverseTap while flushing Top Cover.
( Make sure a drain bucket is in position. )
•Use soft towel or brush to wipe the Top cover. Also, do not apply too much force on Cup sensors which may cause
damage and result in malfunctioning.
•Dry Control panel right after cleaning it with wet towel.
•You may also watch a video related to cleaning at ReverseTap YouTube. www.youtube.com/reversetap
Turn OFF and unplug ReverseTap. Remove Protect Cover
and Nozzle Cover.
Unscrew RT Nozzle.
Hold the middle of Gripper and tilt it
towards the center of Nozzle and pull
up to remove.
Wash the parts with warm water
and food safe sanitizing solution.
Flush the Top Cover with warm water.
Spray a food safe sanitizer and wipe
out any beer build up. Then flush
again with warm water.
Remove moisture and dirt from
Top Panel and Top Cover.
Please be careful not to apply too
much force on Cup Sensors.
Put the Protect Cover,
Nozzle Covers, RT Nozzles, and
Grippers back on their position.
Cup Sensor
ReverseTap Instruction Manual : Dispenser Cleaning (Daily)
Top
cover
Top
panel
Control
panel
Copyright © 2019 NPC Co., Ltd. All rights reserved.
This manual is protected under international copyright laws. No part of this guide may be reproduced, distributed, translated, or
transmitted in any form or by any means, electronic or mechanical, including photocopying, recording, or storing in any
information storage and retrieval system, without the prior written permission of NPC Co., Ltd. US V1.0
