Please ensure these instructions are fully read
and implemented. Failure to do so may result in
injury to the user. Retain in a safe place for
future reference.
Intended Use
The NRS Healthcare Bathroom Step is designed to
assist the user while transferring into or out of the
bath, by reducing the step-over height.
Unpacking
·No tools are required to assemble this product.
(However a flat headed screwdriver, or similar,
would help to remove the caps if the steps are
to be assembled in a multiple stack)
·Remove items from packaging; Check for
damage. If you see any, or suspect a fault, do
not assemble or use the product; contact your
supplier immediately.
·Check all parts are present - see contents list.
M99515 Bathroom Step
There are a number of options and combinations
the steps can be used for.
A single step provides a step height of 4"(100mm)
Single Step Use:
Unpack the step, ensure it is clean and dry,
remove the protective film from the back of the
self adhesive mat and place accurately on top of
the step, ensure the mat is in the recess on the
top of the step and there are no creases, press
down firmly to secure.
Multiple Step Use: Stacking Options
(Steps purchased separately)
Single 4" (100mm)
Two Steps 6" (150mm)
Maximum 3 High: 8" 200mm)
Note: The Anti -Slip mat is placed on the top step
only. Mats supplied with the other steps should be
saved, to be used later as spares.
Stacking assembly
The top step should be assembled as described
in the single step use section.
For all other steps used in the stack, remove the
four caps as shown in diagrams 1 & 2, note: a flat
bladed screwdriver may help to do this. Please
use caution if tools are used.
Weight
Description Qty
100mm (4") Step
(complete with four assembled caps) 1
Anti-Slip Mat (Self Adhesive backed) 1
User Instructions 1
·Do not exceed max. user weight of 127Kg
(20st)
·The maximum step height is 8”(200mm) using
3 steps (purchased separately)
·Do not stack more than 3 steps together.
·Always use extreme caution when getting in or
out of a bath
