Oase Aquarius Universal Eco 3000 User manual

14391/03 F
Aquarius Universal Eco 3000, Eco 4000,
5000, 6000, 9000, 12000
14391 GAW Aquarius A6_end:. 09.03.10 13:14 Seite 2
Downloaded from www.watergardeningdirect.com

2
1 2 3 4 5
DE Motorblock Druckstutzen Durchflussregler/
Saugeinheit Vorfilter Pumpenfuß
GB Motor casing Pressure socket Flow regulator/
suction unit Pre-filter Pump foot
FR Bloc moteur Raccord de tuyau de
refoulement Régulateur de débit/unité d'aspiration Tamis préfiltre Pied de la pompe
NL Motorblok Spuitkop Debietregeling/
zuigeenheid Voorfilter Pompvoet
ES Bloque del motor Tubuladura de presión Regulador volumétrico
de paso / unidad de
aspiración
Filtro previo Pie de la bomba
PT Bloco do motor Bocal de saída de
pressão Regulador do caudal / Unidade de aspiração Filtro de entrada Pé da bomba
IT Blocco motore Tronchetto di pressione Regolatore portata/unità
di aspirazione Prefiltro Piede della pompa
DK Motorblok Trykstuds Gennemstrømnings-
regulator/sugeenhed Forfilte Pumpefod
NO Motorblokk Trykkstuss Gjennomstrømnings-
regulator/sugeenhet Forfilter Pumpefot
SE Motorblock Tryckstos Flödesreglering/sugenhet Förfilter Pumpfot
FI Moottorilohko Painemuhvi Virtaamasäädin/
imuyksikkö Esisuodatin Pumpunjalusta
HU Motorblokk Nyomócsonk Átfolyás-szabályozó/
Szívóegység ElőszűrőSzivattyú-lábazat
PL Blok silnika Króciec tłoczny Regulator przepływu/
zespółssania Filtr wstępny Podstawka pompy
CZ Blok motoru Výtlačné hrdlo Regulátor průtoku/
sací jednotka Předfiltr Patka čerpadla
SK Blok motora Výtlačné hrdlo Regulátor prietoku/
sacia jednotka Predfilter Pätka čerpadla
SI Blok motorja Tlačni priključek Regulator pretoka/
sesalna enota Predfilter Podstavek črpalke
HR blok motora tlačni nastavak regulator protoka/
usisna jedinica predfiltar postolje crpke
RO Blocul motor Ştuţde presiune Regulator de debit/Sorb Filtru anterior Postamentul pompei
BG Двигателен блок Пневматични
накрайници Вентилатор за регулиране на водния
поток/Всмукател
Преден филтър Долна част на помпата
UA Моторний блок Нагнітальний патрубок Регулятор
протоку/всмоктувальни
ймодуль
Фільтр Опора насоса
RU Моторный блок Напорный патрубок Регулятор протока /
Всасывающий узел Предв.фильтр Лапка насоса
CN 电机组 压力管接头 流量调节器/抽吸单元 预过滤器 泵脚
Downloaded from www.watergardeningdirect.com

3
Downloaded from www.watergardeningdirect.com

7
- GB -
Translation of the original Operating Instructions
Information about these operating instructions
Welcome to OASE Living Water. You made a good choice with the purchase of the product Aquarius Universal Eco
3000, Eco 4000, 5000, 6000, 9000, 12000.
Prior to commissioning the unit, please read the instructions of use carefully and fully familiarise yourself with the unit.
Ensure that all work with this unit is only carried out in accordance with these instructions.
Adhere to the safety information for the correct and safe use of the unit.
Keep these instructions in a safe place! Please also hand over the instructions when passing the unit on to a new
owner.
Symbols
The symbols used in this operating manual have the following meanings:
Risk of injury to persons due to dangerous electrical voltage
This symbol indicates an imminent danger, which can lead to death or severe injuries if the appropriate mea-
sures are not taken.
Risk of injury to persons due to a general source of danger
This symbol indicates an imminent danger, which can lead to death or severe injuries if the appropriate mea-
sures are not taken.
Important information for trouble-free operation.
Intended use
Aquarius Universal Eco 3000, Eco 4000, 5000, 6000, 9000, 12000, in the following termed "unit", and all other parts
from the delivery scope may be used exclusively as follows:
−For pumping clear water used for indoor and outdoor fountain pumps, table fountain pumps and statues.
−For operation with clean water.
−Operation under observance of the technical data.
The following restrictions apply to the unit:
−Do not use in swimming ponds.
−Never use the unit to convey fluids other than water.
−Never run the unit without water.
−Do not use for commercial or industrial purposes.
−Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
Attention! Risk of damage!
Ensure that the unit does not take in air or run dry. Do not connect the unit to the domestic water lines.
Safety information
The company OASE has built this unit according to the state of the art and the valid safety regulations. Despite the
above, hazards for persons and assets can emanate from this unit if it is used in an improper manner or not in accor-
dance with its intended use, or if the safety instructions are ignored.
For safety reasons, children and young persons under 16 years of age as well as persons who cannot re-
cognise possible danger or who are not familiar with these operating instructions, are not permitted to use the
unit. Keep children under supervision to ensure that they do not play with the unit.
Hazards encountered by the combination of water and electricity
−The combination of water and electricity can lead to death or severe injury from electrocution, if the unit is incorrectly
connected or misused.
−Prior to reaching into the water, always switch off the mains voltage to all units used in the water.
Correct electrical installation
−Electrical installations must meet the national regulations and may only be carried out by a qualified electrician.
−A person is regarded as a qualified electrician, if, due to his/her vocational education, knowledge and experience, he
or she is capable of and authorised to judge and carry out the work commissioned to him/her. Working as a qualified
person also includes the recognition of possible hazards and the adherence to the pertinent regional and national
standards, rules and regulations.
−For your own safety, please consult a qualified electrician.
−The unit may only be connected when the electrical data of the unit and the power supply coincide. The unit data is
to be found on the unit type plate or on the packaging, or in this manual.
- GB -
Downloaded from www.watergardeningdirect.com

8
- GB -
−Ensure that the unit is fused for a rated fault current of max. 30 mA by means of a fault current protection device.
−Extension cables and power distributors (e.g. outlet strips) must be suitable for outdoor use.
−Ensure that the power connection cable cross section is not smaller than that of the rubber sheath with the
identification H05RN-F. Extension cables must meet DIN VDE 0620.
−Protect the plug connections from moisture.
−Only plug the unit into a correctly fitted socket.
Safe operation
−Never operate the unit if either the electrical cables or the housing are defective!
−Do not carry or pull the unit by its electrical cable.
−Route all cables such that damage is excluded and nobody can trip over them.
−Never open the unit housing or its attendant components, unless this is explicitly required in the operating
instructions.
−Only use original spare parts and accessories for the unit.
−Never carry out technical modifications to the unit.
−Only have repairs carried out by customer service points authorised by OASE.
−Keep the socket and power plug dry.
−Only operate the unit if no persons are in the water!
Aquarius Universal Eco 3000/4000:
−The power connection cables cannot be replaced. When the cable is damaged, the unit or the component needs to
be disposed of.
Important! The unit is equipped with a permanent magnet. The magnetic field may affect the function of pace-
makers.
Installation
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
−Prior to reaching into the water, disconnect the power supply to all units used in the water.
−Disconnect the power plug prior to carrying out work on the unit.
The unit can be set up either submerged (A) or dry (B).
General preparatory work: Bolt on the suction unit (3) and fit the pressure socket (2). Connect the desired hose for the
water feature to the pressure socket. Adapt stepped hose connectors to the water supply and return in accordance with
the hose diameter (C). Remove the pump foot, if necessary. For this purpose, press the pump foot to the rear, as
illustrated (D)
Submerged installation (A)
Operation with the pre-filter fitted. Push the pre-filter over the suction unit and fasten the filter using the bayonet closu-
re. Place the unit in the water at the desired position. Ensure that the unit is fully submerged. Maximum installation
depth:4 metres.
Dry installation (B)
Bolt the suction unit on and turn the priming opening to an optimum position for priming and connecting the suction
hose. Connect the suction hose to the suction unit. Always position the unit below the water line to prevent dry running
and the intake of air when switching on and operating the unit. Risk of damage!
Never connect the unit to a water line.
Install the unit so that it is not exposed to direct sun radiation (max. 40 ºC).
Start-up
Attention! The pump must never run dry.
Possible consequence: The pump will be destroyed.
Protective measure: Check the water level at regular intervals. Always place the unit below water level.
Downloaded from www.watergardeningdirect.com