Odyssey THE RIPPER User manual

1
INSTRUCTION MANUAL: THE RIPPER 8+
SETTING UP THE RIPPER
1. Turn off the power switch.
2. Using a phillips screwdriver open the
battery compartment.
3. Connect the battery wire to The
Ripper’s connector as shown on the
diagram.
4. Close the battery compartment and
reinstall the screw.
5. Turn the power switch to On.
FOR
AGES
Power Switch

2
SETTING UP THE REMOTE CONTROL
CHARGING THE RIPPER’S BATTERY
OPERATING THE RIPPER
Tip. For best results the car needs to be within a 150 foot range of the controller.
Tip. Full charge takes up to 3-4hrs
1. Remove the battery from The Ripper
as shown in the setting up instructions.
2. Connect The Ripper’s battery to the
USB charging cord connector.
3. Plug the USB cord into a 5v1a USB
charger.
4. The charger light will turn on to indicate charging. When the charger light
goes out charging is complete and you can reinstall the battery in The Ripper.
Controller Functions
1. Using a phillips screwdriver open the
battery cover on the base of the
controller.
2. Install 4x new AA batteries taking care
to match the correct polarity (+/-).
3. Close the battery cover.
Steering Wheel
(Left & Right Turning)
Forward & Reverse Throttle
Controller
On/Off Switch
Max. Speed Control
Transmit
Indicator Light
Steering Trim
Adjustment
Controller On/Off
Indicator Light
Adjust Steering
Sensitivity
USB Charging Cord
LiPo
Battery
AA Batteries

3
Tip. If The Ripper pulls to the
left or right when driving
forwards without steering
from the controller, you
should adjust the steering
trim.
The Ripper Movement
The Ripper Steering Trim Adjustment
The Ripper Steering Sensitivity Adjustment
If the vehicle pulls to the left
adjust the trim setting to the
right until the vehicle travels
in a straight line.
If the vehicle pulls to the
right adjust the trim setting
to the left until the vehicle
travels in a straight line.
Turn the sensitivity control
counter clockwise to
decrease steering sensitivity.
Turn the sensitivity control
clockwise to increase
steering sensitivity.
Turn the control counter
clockwise to decrease
maximum speed.
Turn the control clockwise
to increase maximum speed.
Tip. If The Ripper’s steering is
too sensitive for your driving
style you can adjust the
sensitivity.
The Ripper Max. Speed Control
Tip. If you find The Ripper’s
high speed hard to control
you can limit the top speed
with the Max. Speed Control.
Forward: Pull down on the throttle
to drive the vehicle forwards.
Adjust the throttle position to
control the speed of the vehicle.
Forward & Turn Left: Pull down on
the throttle while turning the
steering wheel to the left.
Reverse & Turn Left: Push up on the
throttle while turning the steering
wheel to the left.
Forward & Turn Right: Pull down on
the throttle while turning the
steering wheel to the right.
Reverse & Turn Right: Push up on
the throttle while turning the
steering wheel to the right.
Reverse: Push up on the throttle to
drive the vehicle in reverse.
Adjust the throttle position to
control the speed of the vehicle.

4
CARE & MAINTENANCE
CAUTIONS & WARNINGS
•¡Suitable for ages 8 and up. Adult supervision is always recommended.
•¡This product contains small parts which are a choking hazard. Keep
away from small children.
•¡Manufacturers and dealers disclaim all responsibility for damage caused
by misuse.
•¡Keep hair and loose clothing away from the vehicle when powered on.
•If The Ripper will be stored and unused for an extended period of time,
please remove the batteries.
•Check the batteries regularly for potential leakage or corrosion that may
occur.
• When installing the batteries carefully follow the polarity marking +/-.
•Do not mix different battery types.
•¡Remove exhausted or drained batteries.
•¡Do not exceed charging volts and amps of 5v1a.
•¡Do not leave charger connected or charge for more than 1hr.
• Do not submerge the unit in any liquids.
• Keep the unit dry.
•¡Do not place the unit near powerful, un-shielded magnets.
•¡Do not expose the unit to extreme hot or cold temperatures.
•¡Do not hit, drop, or smash the unit with extreme force.
•¡Do not disassemble the unit for any reason.
NOT FOLLOWING THESE PRECAUTIONS WILL VOID YOUR WARRANTY.
For Customer Service please email:
[e-mail]
Please note the units model number and name in your email:
Model no. ODY-1030 •¡The Ripper
www.OdysseyToys.com
FCC STATEMENT: This product complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference and (2) this
device must accept any interference receiver, including interference that may cause undesirable
operation.