OfficeSource PLTEAB4872BUDECONF User manual

Before assembly, please remove all parts from the carton, verifying that you have the correct quantities, and read all the instructions.
1 of 4
®
ASSEMBLY INSTRUCTIONS
MODEL: PLTEAB4872BUDECONF
!ATTENTION !
Ensure all bolts and screws are tightened, check bolts and screws every 6 months.
If any parts are missing, broken, damaged or worn, stop use of product until repairs have been made using factory authorized parts.
Failure to follow these warnings may result in injury.
ASSEMBLY INSTRUCTIONS
Last Updated: 02/2021

2 of 4
®
ASSEMBLY INSTRUCTIONS
MODEL: PLTEAB4872BUDECONF
Part Lists
No. Name Drawing QTY
aCenter Trunk 1
bColumn 2
cSide Support 2
dScrew M6x10 8
eHandset 1
fScrew 5x20 24
gScrew 3x20 2
HPower Cable 1
IAllen Key 5 1
a
b
b
c
c
d
I
Step.1
Step.
2
Place the Table Leg Frame on the
bottom side of the table top
Last Updated: 02/2021

3 of 4
®
ASSEMBLY INSTRUCTIONS
MODEL: PLTEAB4872BUDECONF
e
f
H
g
A
B
Tighten up the screws
Detail A
Detail B
Extend the trunk to fit table size
Step.3
Step.4
Step.5
Put Handset's connecting
line through the hole
below the Left Trunk
Last Updated: 02/2021

4 of 4
®
ASSEMBLY INSTRUCTIONS
MODEL: PLTEAB4872BUDECONF
※ Important ※
Reset the table before use :
1. Press and hold ∧&∨for more than 3 seconds
2. Continue pressing both buttons until both columns are in the lowest position
3. The table will rebound 2-5mm
4. Release the buttons, now the table is operational
Step.6
S
2 31 4
Last Updated: 02/2021