Omega Caliber 1866 Speedmaster User manual

1 / 2
SPEEDMASTER
MOONWATCH PROFESSIONAL MOONPHASE CHRONOGRAPH 44.25 MM
Steel on leather strap
Caliber
1866 311.33.44.32.01.001
cManual
/Moonphase
ZTachymeter
oSapphire crystal
tAnti-reflective treatment on both sides
DSapphire crystal case back
E2-year International Warranty
TWater-Resistant to a relative pressure of 10 bar
(100 metres/330 feet)
WATCH FUNCTIONS
The crown has 2 positions:
1. Normal position (wearing position): when the crown is positioned against the
case, the crown ensures that the watch is water-resistant.
Winding: turn the crown forwards until it stops (DO NOT OVERWIND).
Note: do not wind the watch more often than is necessary. For a watch that is
worn all the time, a single winding each day will ensure that it functions correctly.
2. Time setting: hours – minutes – seconds. Pull the crown out to position 2. Turn
the crown forwards or backwards. Synchronise the seconds by pushing the crown
back to position 1 to coincide with a given time signal.
Note: The calibre does not have a ’stop second’ mechanism. To synchronise, the
crown should be gently turned backwards and pressure maintained to stop the
seconds hand. Release when the display corresponds to the timing signal and
push crown back to position 1.
CHRONOGRAPH FUNCTIONS
• Pusher A: start – stop, start – stop, etc
Timing to 1/6 of a second for up to 12 hours.
• Pusher B: reset (after a stop).

2 / 2
DATE AND MOON PHASE CORRECTION
Correcting the date (small counter at 12 o’clock): press corrector (C).
Correcting the moon phase: press corrector (D) to move the disc into the full-
moon position. Then determine how many days have elapsed since the last full
moon (consult a calendar) and press the corrector the equivalent number of
times.
When the watch is running, the date and moon phase move forward
automatically.
Important: avoid pressing correctors (C) and (D) (date and moon phase) if the
watch is displaying any time between 7 and 12 o’clock (am or pm).
Do not set the date by moving the hour hand past midnight, since this may
desynchronise the date and moon phase indicators.
TACHYMETRIC SCALES
The desired information is read between the central seconds hand of the
chronograph and the corresponding scale, over a maximum duration of 60
seconds.
Example: calculating the speed of a car.
Record the time the car takes to cover a distance of 1 kilometre. Read off the
tachymetric scale the speed indicated by the central seconds hand. In this case,
the car is travelling at 120 km/h.
FOLDOVER CLASPS
Opening (fig. 1): to open the clasp, press the two pushers on either side of the
OMEGA buckle and pull upwards.

Closing (fig. 2): put the watch on your wrist and close the clasp by pushing on it
with your thumb until you hear a click. (fig. 2).

Adjusting the length (fig. 3): free the longer section from the two slideways
(A) and from the catch (B). Adjust the bracelet in the required direction and
reinsert in the catch and the two slideways. Try the watch for size and readjust if
necessary.