6
SETUP
LEARNING
Your Essence remote control can learn any function from
any other working remote control. This is a quick and easy
one-time setup that allows you to control any infrared
controlled device you have in your living room. It also allows
you to add a key or keys that may be missing to a spare key
on the Essence.
To do this, rstly make sure you have all your original remote
controls to hand, and that they have working batteries in.
To learn functions, the original remote should be approxima-
tely 2-5 cm from the Essence remote, pointing towards it:
1. Hold down the SETUP key until the LED
blinks twice.
2. Press 975 – the LED should blink twice.
3. Press and release the key you want to
learn a function onto (for example the
POWER key) – the LED will begin to ash
rapidly.
4. Press and release* the corresponding
key on the original remote, for example
POWER.
5. The LED will blink twice to indicate the key has been
learned correctly.
6. Repeat steps 3 and 4 for each key you want to learn –
remember you can learn from multiple remotes, but
only one function per key.
7. When you have learned all the functions
you require, press and hold SETUP key
until the LED blinks twice.
* Some remotes send commands dierently. If you nd a
function cannot be learned, try holding down the key on
the original remote instead of pressing and releasing.
Hints:
• If the LED shows one long blink at step 5, the function was
not learned correctly, please try again from step 4.
• If you nd one or more keys don’t work properly after set
up, you can re-enter the learning mode at any time by
repeating the procedure from step 1.
• If one or more of your original remotes aren’t working, you
can still set up the Essence remote by SimpleSet or Code
Set Up.
Deleting a learned function
If you want to delete a learned function and return that key
to its original state, you can use the following procedure:
1. Hold down the SETUP key until the LED
under the Device key blinks twice
2. Press 976 – the LED should blink twice
3. Press the key you want to reset twice – the LED
should blink twice and the learned function has been
deleted.
2 - 5 CM
713376 Essence-TV CAN_Manual URC2110 RDN1011222 incl. Codelist_75x250.indd 6713376 Essence-TV CAN_Manual URC2110 RDN1011222 incl. Codelist_75x250.indd 601-12-2022 16:2001-12-2022 16:20
