Onicon F-1000 SERIES User manual

TECH NOTES
F-1000 Series Turbine Flow Meters
BLUETOOTH®INSTALLATION INSTRUCTIONS
ON I CON
Flow and Energy Measurement
DOC-0003909 Rev.A
OVERVIEW
ONICON’s F-1000 Series Turbine Flow Meters can be easily updated in the eld with
the Bluetooth interface*. Bluetooth enables wireless access to real-time data for fast
commissioning and advanced diagnostics.
TOOLS REQUIRED
• #2 Phillips Head Screwdriver
F-1000 SERIES ENCLOSURE DIAGRAM
JTAG HEADER CONNECTION USB CONNECTION
*for meters shipped after March 2016
BLUETOOTH COVER DIAGRAM
P1 HEADER
USB MICRO CONNECTOR

ON I CON
Flow and Energy Measurement
11451 Belcher Road South • Largo, FL 33773 • USA • (P) 727.447.6140 • (F) 727.442.5699
[email protected] • onicon.com
F-1000 Series Turbine Flow Meters
BLUETOOTH®INSTALLATION INSTRUCTIONS
INSTALLATION PROCEDURE
CAUTION
Do not make cable connections while the ow meter is powered. Conrm connection is correct before applying
power to the ow meter.
IMPORTANT NOTES
The clearance required for insertion meter installations with the Bluetooth cover is 25.5” – 38.5” from the pipe
wall to the nearest obstruction above the valve assembly. This clearance dimensions will increase with large
diameter pipes.
Allow at least 8.5” of clearance for inline meter installations with the Bluetooth cover.
1. Disconnect the power.
2. Use a #2 Philips head screwdriver to loosen the electronics enclosure screws.
3. Remove the enclosure cover and replace with the Bluetooth cover.
4. Connect the Micro USB connector located on the Bluetooth cover into the USB connection inside the meter’s
electronics enclosure.
WARNING
The Micro USB connector inside the turbine meter enclosure can be easily damaged if the cable is not plugged
straight into the connector. Please ensure the cable is only pushed straight in or pulled straight out.
5. Connect the P1 header connector located on the Bluetooth cover into the JTAG header connection inside the meter’s
enclosure.
IMPORTANT NOTE
Ensure the P1 header connector is connected in the correct position or the Bluetooth connectivity will be aected.
See image below.
6. Use a #2 Phillips head screwdriver to tighten the electronics enclosure screws.
7. Reconnect the power.
8. Refer to the F-1000 Series Quick Start Guide and F-1000 Series Utility Installation and Operation Guide for further
instructions to wirelessly transmit real-time meter data directly to a PC.
If you have any questions or need assistance with the installation, please contact ONICON Technical Support at
[phone] or [email protected].