Operative Experience Tactical Hemorrhage Control Trainer User manual

+Fill the reservoir on the hand pump with simulated blood.
+Lift the penis and extend the blood fill port.
+Attach the blood fill hose by snapping onto the blood fill
port on the simulator located under the penis. (Be sure the
hose nozzle is free of debris.)
+Retract the handle and pump approximately three times or
until the simulator’s blood reservoir is full.
3 Add Blood to the Simulator
1Equipment Identication
+Simulator +Battery Pack
and Charger
2Charge Battery
+Plug into a standard electrical outlet. The red light
indicates charging.
+Charge the batteries for 6 to 8 hours (or overnight).
The indicator light turns green when the batteries
are fully charged.
QUICK START GUIDE
To get started, please follow these easy steps:
+To install the battery pack, remove the skin cover on the
upper left thigh to access and open the compartment.
Then, attach the pack to the connector, and place the
pack inside the compartment.
4 Install Battery
Tactical Hemorrhage
Control Trainer
+Hand Pump
(for blood)

operativeexperience.com | 500 Principio Parkway West, Suite 900 | North East, MD 21901 | 410-287-5748 © 2018 Operative Experience, Inc.
Questions and Support
Contact us if you have a question or need help
with your simulator.
Phone: [phone]
Email: [email protected]
+Use the remote“key fob”controller to turn the blood
flow on and off. Hold down the top button for
blood flow “on”and release for “off”.
+Press the on/off switch located in the battery compartment.
The light will turn blue when it is on.
+Allow simulator to cycle through the powering up sequence
+Close the battery compartment and replace the skin.
5Powering On 6Running the Blood
QUICK START GUIDE
Tactical Hemorrhage Control Trainer