Ortech VT-40W User manual

WARNING
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.
1. LED Vapour Tight can only be installed by a qualified electrician
2. Before installation or maintenance, please disconnect the power to prevent electric shock
3. Any non-professionals are not allowed to disassemble the lamp
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES. Electrical products can
cause death or injury, or damage to property. If in any doubt about the installation or use of this product, consult a competent
electrician. Turn off the main power at the circuit breaker before installing the fixture, in order to prevent possible shock.
APPLICATION NOTICE
LED Vapour Tights
MODEL VT-40W | VT-40WMS Instruction Manual
•DO NOT cover the fixtures with flammable materials
•Lamps should always be installed or replaced with care
•Misuse of, or changes to the fixture shall nullify the guarantee
•Before installing the lighting fixtures, please read this instruction manual carefully
•When a lamp is to be cleaned, make the power off and let it cool down completely.
Clean the fixture with a soft cloth and a standard PH neutral detergent
CAUTION
AUTION
ORTECH reserves the right to modify at any time, without notice, any or all of our product's
features, designs, components and specifications to meet market changes.
CAUTION
INSTALLATION GUIDE
•Check the local voltage in accordance with the product requirements
before using the product. Exclusively replaced by the manufacturer or his
service agent or the similar qualified person in order to avoid a hazard
•The lighting fixtures should be installed, connected and tested by a
certified installer based on the local regulations
•Re-lamping only can be done when the power is off and the lamp is
completely cooled down
CAUTION
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Mississauga, ON L5T 2N1

LED Vapour Tights
MODEL VT-40W | VT-40WMS Instruction Manual
ORTECH reserves the right to modify at any time, without notice, any or all of our product's
features, designs, components and specifications to meet market changes.
INSTALLATION GUIDE
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Mississauga, ON L5T 2N1
MICROWAVE SENSORS INSTALLATION
In order to avoid mutual interference during the operation of motion sensor, the
installation distance between lamp and lamp shall not be less than one meter.
built-in microwave
motion sensor
WIRING DIAGRAM
L
N
L
N
LED Driver
LED+
LED-
GND MC090D RC
DIM-
DIM+
12V
0-10V
Yellow: GND
white: 12V
white:0-10V
12V+
12V-

LED Vapour Tights
MODEL VT-40W | VT-40WMS Instruction Manual
ORTECH reserves the right to modify at any time, without notice, any or all of our product's
features, designs, components and specifications to meet market changes.
SURFACE MOUNTED INSTALLATION
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Mississauga, ON L5T 2N1
SUSPENDED INSTALLATION