OPERATION
6
• Always make sure the device
is disconnected before cleaning.
• Do not use abrasive cleaning materials,
organic cleaning products (alcohol,
gasoline etc.).
• When cleaning the device it is allowed to
use a small amount of neutral detergent.
• Make sure that the switch is in the
OFF position after each use. Before
disassembling the device, also make sure
that the motor has stopped completely.
• Do not put your fingers or any other foreign
objects into the hopper during operation.
If there is an obstruction in the hopper,
use a pusher. If it doesn’t work, turn
off the device and disassemble it,
removing all the food remains.
• Carry the device only by holding its base.
• Do not use this device without pulp
container.
• If the screw instantly stops rotating, stop
using the device and use the “REV”
function for 3-5 seconds.
• To avoid overheating of the motor, do not
use the device more than 30 minutes
nonstop. Make a 5-minute pause and let
the device cool down.
• Weight of the device is approximately 6.45
kg. Be careful and cautious when moving
it in order to avoid injury or damage to the
device.
• In order to avoid possible malfunctions of
the device, do not wash it in hot water with
a temperature above 80°С, because some
elements are made of silicone.
• If the mesh filter is damaged, stop using the
device and contact the authorized service
center (ASC) OURSSON AG.
NOTE! The operation of this device
in any case does not imply
application of any force to it,
as this may damage the product
due to user fault.
