Outdoor Lifestyles ODCOUG-36SCN User manual

Outdoor Lifestyles. • Courtyard Optional Screen Install Instructions • 4150-930 Rev. A • 02/23
CAUTION: Allow appliance to cool completely before
attempting to install or remove screen.
Before You Start
This optional screen allows a layer of protection for your
outdoor gas appliance from leaves, branches and other
large debris and is designed to be left in place during op-
eration. Read instructions completely before installing op-
tional screen. This screen can be installed easily after unit
installation or at any time after.
KIT CONTENTS:
• (1) Screen Assembly
• (1) Hood
• (1) Inner Hood
• (1) Fastener Pack
INSTALLATION INSTRUCTIONS:
1. Inspect new Screen Front for any damage.
2. Locate and loosen the (4) screws securing the exist-
ing appliance hood. Remove the hood and discard. A
replacement hood has been provided for use with this
optional Screen Front kit. See Figure 2.
Figure 1
Figure 2
Model Kit
ODCOUG-36NR ODCOUG-36SCN
ODCOUG-36TS
ODCOUG-42NR ODCOUG-42SCN
ODCOUG-42TS
Installation
Instructions
This kit has been tested for use with specic Hearth & Home Technologies products. Check with your local building code
agency before you begin installation to ensure compliance with local codes, including the need for permits and follow-up
inspections. If you encounter any problems regarding code approvals, or if you need clarication of any of the instructions
contained here, contact your Hearth & Home Technologies dealer. For the dealer nearest you, please visit www.hearthn-
home.com.
For use with Courtyard Outdoor Gas Appliance.
3. Locate (1) screw securing the right-side mesh screen
and screen rod in place and remove. See Figure 3.
4. Lower the center of the screen rod to disengage rod
from the mounting hole located on the right side of the
appliance. Repeat this process on the left-side mesh
screen. Set aside, mesh screens will no longer be
needed.
Courtyard Optional Screen
Models: ODCOUG-36SCN, ODCOUG-42SCN
Hood
Inner
Hood
Screen Assembly

Outdoor Lifestyles. • Courtyard Optional Screen Install Instructions • 4150-930 Rev. A • 02/23
Please contact your Hearth & Home Technologies dealer with any questions or concerns. For the
location of your nearest Hearth & Home Technologies dealer, please visit www.hearthnhome.com.
Figure 3
5. Install replacement hood and tighten (4) screws to se-
cure.
6. To install Lower Hood, bend (4) hand tabs on Lower
Hood up at approximately 30 degrees. See Figure 4.
Note: Mesh screens and rods cannot be used with the op-
tional screen kit.
7. Position Lower Hood on front edge of rebox top, as
shown. Secure the hood with (4) screws provided. See
Figure 5.
Figure 4
Screws
Figure 5
Note: Bent tabs should be on the top side of the rebox top.
8. Locate the screen mounting slots (4) inside of the appli-
ance opening. Mating mounting tabs (4) are located on
the right and left sides of the Screen Front. See Figure
6.
Mounting Slots
Figure 6
9. Lift the Screen Front and hang on the appliance, en-
suring that all tabs are inserted into the mounting slots.
See Figure 7.
Mounting Tabs
Figure 7