Owon SPD2100 User manual

SPD2100 Smart Pet Water Fountain
Quick Start Guide

Preface
Thank you for choosing our smart pet water fountain. We sincerely hope
to help you create a high-quality pet life. Before using this product, please
read our product user manual carefully.
Safety Precautions
Product Diagram
Drinking tray
Filter box
Tray
Outlet pipe
Water level window
Water bucket
Base
Mode selector switch：
：Continuous water
：Intermittent water
the water is discharged
for 10 seconds and stop
for 5 seconds.
Indicator light

• When the device is not in use, be sure to disconnect the power
supply for safety.
• After wiping or changing the water, please put the water bucket back
on the base in time.
• Do not immerse the base in water. When wiping the base, please
disconnect the power and make sure that the power contact hole is dry
and free of water stains before turning on the power again.
• Before using the device with power, make sure that the water level in
the water bucket is within the water level range.
• Do not drop this product or subject it to strong impact.
• After cleaning the bucket, please make sure the bottom of the
bucket is dry before placing it in the base.
• The 󶄕lter box is recommended to be replaced in 2 or 4 weeks, and
cannot be reused.
Warning:
Before using the smart pet water fountain, please read all the
following safety precautions carefully. Failure to observe these safety
precautions may cause 󶄕re, electric shock, other injuries or damage
to life and property.
Anti-skidding mat
Micro USB port
Trunking

Product Speci󶄕cation
Capacity • 2.5 Liters
Power supply • 5V /1A
Dimensions • 175 x 185 x 165 mm
Operation Guide
1. Take out the water fountain and
internal accessories;
2. Rinse the water bucket and the
outlet pipe with clean water;
3. Insert the outlet pipe into the
outlet hole of the silent water pump,
and press it 󶄕rmly;
4. Add water to the water bucket,
and do not exceed the highest water
level;
5. Install the tray;
6. Rinse the filter box with clean
water and put it into the tray filter
box slot;
Note:
When the water bucket needs to be cleaned, the red light of the
indicator is always on. After cleaning, please power on the device to
restore to normal state. (The cleaning reminder time is 7 days.)
7. Install drinking tray;
8. Adjust the mode switch on the
base to select the water outlet mode;
9. Insert the USB cable into the Micro
USB socket, and press the cable into
the slot (as shown on the right), place
the entire base in a stable place;
10. Connect the base to the power
supply, and place the water bucket
on the base. The water fountain
indicator lights up and starts to work.

Indicator Function
The purple light is
always on. The water
comes out intermittently.
The blue light is always
on. The water comes
out continuously.
The red light is 󶄖ashing.
The water level is lower
than the lowest water
level, the water stops.
The red light is always
on. The water bucket
needs to be cleaned.
Please power o󶄔 for
cleaning, and then
power on.