Ozito GCC-160A User manual

ASSEMBLY
GARDEN
COLLECTION CART
160L
INSTRUCTION MANUAL
1 Scoop
2 Upper Handle
3 Lower Handle x 2
4 Base
5 Locking Collar x 2
6 Locking Tab x 2
7 Wheel x 2
8 Wheel Cap x 2
9 M5 Washer x 2
10 M5 Nut x 4
11 Split Pin x 2
12 M5 x 20mm Screw x 2
13 M5 x 40mm Screw x 2
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
5
6
12 3
789 10 11 12 13
4
1. Fit upper handle onto lower handle and secure using the 2 M5 x 20mm
screws and nuts.
2. Fit handle assembly onto base and secure using the
2 M5 x 40mm screws
and nuts.
4. Ensure both ends of
the split pin are bent
to secure wheel on
axle.
5. Attach scoop onto top
handle.
3. Attach wheels onto axle.
GCC-160A
ozito.com.au

ASSEMBLY (cont.) OPERATION
STORAGE
6. Hold down both sides of the collection bag and release the 2 locking tabs. • Use the scoop to collect garden waste and empty into
collection bag.
• Place collection cart onto its side with
the scoop fitted to the handle and
rake/sweep leaves directly into the
bag.
1. Release the 2 velcro straps
and carefully lower the
collection bag.
2. Attach the locking tabs on either side of the base to secure the bag in
position.
3. Slightly raise the 2 handle support
tubes.
5. Store the collection cart in your
garage/shed.
4. Fold over the handle and secure
using the 2 locking tabs.
7. Slowly raise the collection bag to
the fully upright position.
8. Attach the 2 velcro straps to
hold collection bag in position.
9. Fit garden tools (not
included) onto the
cart using the support
holes in the base and
locking tabs on the
handle.
10. Assembly is complete!