OZONA THL001-MIZ2 User manual

Please keep this instruction for future reference.
The picture is for reference only. Please adhere to the original products.
INSTRUCTION
【FREE-STANDING ELECTRIC HEATER】
THL001-MIZ2

This manual contains important safety information concerning the maintenance, use and operation of this
product. Failure to follow the instructions contained in this manual may result in serious injury. If you are
unable the contents of this manual, please bring it to the attention of your supervisor. Do not operate this
product unless you have read and understand the contents of this manual.
IMPORTANT SAFETY MEASURES
When using any kind of electrical appliance, some basic safety precautions must always be followed,
including the following:
1) To avoid possible electric shocks, do not place the cable, plug or appliance in water or in any other
liquid. Do not insert screwdrivers or metallic items inside the appliance.
2) If the power cable is damaged, it must be replaced by the manufacturer, its service technician or by
someone else authorized by the manufacturer. In the event of handing of appliances by non-
authorized people, the guarantee will immediately cease to be valid.
3) Do not use appliances if they are damaged.
4) To disconnect electrical appliances, wait until the heater stops and then unplug the cable from the
electric socket.
5) Do not leave appliances working unattended. Ensure that the heater has come to a complete stop
before dismantling appliances. Unplug appliance after each use.
6) Do not allow children to use electrical appliance. Do not leave appliance unattended when in use close
to children.
7) Children of less than 3 years should be kept away unless continuously supervised.
8) Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that
it has been placed or installed in its intended normal operating position and they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the
appliance or perform user maintenance.
9) Do not dispose of this product as unclassified municipal rubbish. Due to the use of electrical and electric
parts, this product must be collected separately.
10) CAUTION — Some parts of this product can become very hot and cause burns. Particular attention
has to be given where children and vulnerable people are present.
11) WARNING:The appliance shall, under no circumstances, be covered with insulating material or similar
material.
12) The heater must not be located immediately below a socket-outlet.
NOTICE
1) The power supplied to this unit must comply with electrical requirement on its label. Damage or fire
may result if the incorrect power used.
2) Do not use the heater in somewhere with flammable objects, gas, dust.
3) In order to avoid scalding, forbid to touch the heater when it works.
4) Forbid to put anything on product surface when it is working.
5) To avoid possible electric shocks, do not place the heater in bathrooms or similar indoor location.
6) In order to avoid fire, do not use the heater with automatic electrified sequencer, timer and other
devices.
7) Children of less than 3 years should be kept away unless continuously supervised. Children shall not
play with the appliance.
8) Children aged form 3 years and less than 8 years shall only switch on/off the appliance provided that
it has been placed or installed in its intended normal operating position and they have been given

supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the
appliance or perform user maintenance.
9) Turn off all switches and unplug the heater if an emergency situation occurs.
10) Please contact with seller if it does not work properly. Do not try to repair the heater by yourself.
11) Please contact the seller if you find other problems not covered in this operation manual.
12) Cleaning and user maintenance shall not be made by children with supervision.
SPECIFICATION
INSTALLATION
Please check all the items against the parts list after opening the box. Only all the items are complete, the
installation could be followed.
Step1 Step2 Step1：
Fix the down pole on base by clockwise rotation,
then feed the cable from base to pole.
Step2：
Rotate rest down poles clockwise together, then
connect top pole by same way. Run the cable
though all the poles.
Step3
Model: THL001-MIZ2 Parts Description Quantity
Feature：Rocker Switch A Heater Head 1
Remote: No B1 Top Pole 1
Voltage: B100-120V~60Hz 2 Down Pole 3
Power: 0/1500W C Base 1
Weight: 13.9 kg D Screws 2
Size: 50 x 50 x 205 cm E Cable clip 1
F Manual 1
Point To Heater Head

Step3: Connect the plug on the heater head to the power cable plug. Install
the clip as illustration.
*There is an arrow print on the clip. Please ensure the arrow point to heater
head.
* Please make sure the clip installed in correct position.
* If cable connector stuck in the pole, please change its angle when feeding
the cable.
Step4
Step5
Step4: Push the heater head onto the pole,
aligning the holes on the heater head and the
tube. Once aligned, fix in position using 2 screws.
Step5: Fix cable on the base slot by unscrewing
the 4 screws from plastic fittings. Then secure the
cable by screwing 4 screws.
Operation
“”for 1500W
“”heater OFF
*Please keep at least 50cm distance between heater top and ceiling when using heater.
CLEANING AND MAINTENANCE
1) Always turn off and unplug the heater before cleaning.
2) To clean the heater, use a damp cloth and make sure to dry excess water once cleaned.
*ATTENTION Do not put the heater directly into any container with water in it.
To comply with European Directive 2002/96/EC concerning old electric and electronic
equipment and its implementation in national laws, old electric tools have to be separated from
other waste and disposed of in an environment-friendly fashion, e.g. by taking to a recycling
deport.
TROUBLE SHOOTING
1) If the heater does not emit heat after turning on, please check the power cord whether plugged into
electric socket properly.
2) In first use, it is normal if the heater appears small amount of smoke and some smell because of
protective-oil evaporation.
3) If the cable couldn’t through the pole while assemble heater，please check the whether the clip is in
correct position. The arrow should point to the heater head.
4) If cable clip in correct position but cable still can’t through the pole, please try rotate the clip to
through the pole from different angles.
Cable
Pole