P-Squared 3DR Solo Pro PRCS User manual

Warranty
This product carries a One year Limited Warranty- for a period of one year from the
date purchase, P-Squared Group shall repair or replace, at our discretion, defective
equipment covered by this warranty. This warranty does not cover cosmetic
damages and damages due to acts of God, accident, misuse, abuse, negligence,
improper installation or damages caused by alterations by unauthorized
persons. This warranty only applies to the original purchaser of this product.
Instruction Manual
Important Safety Information:
This manual contains important safety and
operating instructions. Thoroughly read all the
instructions and cautionary notes before you
use your 3DR Solo Pro PRCS.
Instruction/Safety Manual
3DR Solo Pro PRCS
(Portable Rapid Charging System)
Please check website for further details and
changes!
http://www.p-squaredgroup.com/manuals
For help or Service Contact:
P-Squared Group, LLC
719-776-9146
P-squaredgroup.com
Please visit our website for the latest edition of this and all
our other instruction manuals.

Instruction/Safety Manual – 3DR Solo Pro PRCS
Thank you for purchasing P-Squared Group’s 3DR Solo Pro PRCS.
Please read this Instruction/Safety Manual fully before charging any
batteries.
This product is to be used with the 3DR Solo Pro of Intelligent Flight
Batteries (not included).
The 3DR Solo Pro PRCS will allow you to charge up to four batteries
simultaneously, in the same amount of time traditional chargers will charge
one. The 3DR Solo Pro PRCS is also a convenient storage/carrying case.
Features:
3DR Solo Pro PRCS (batteries not included) is a true intelligent rapid
charging system that intelligently manages the charging current, voltage
and temperature during charging as well as being a convenient, lightweight
storage and carrying case.
In the box:
One 3DR Solo Pro PRCS
Instruction/Safety Manual
AC/DC power Supply
AC Power cord
Charging
1.Place your 3DR Solo Pro PRCS on a hard, flat surface before starting
charging process. Insure nothing is restricting air flow in or around your 3DR
Solo Pro PRCS.
2.Securely insert your 3DR Solo Pro batteries – top facing out - into 3DR Solo
Pro PRCS’s charging slots.
3. Plug the AC power cable into the AC/DC power supply.
6. Plug the AC power cable into your AC power source (wall receptacle,
generator, etc.).
7. Batteries will automatically begin charging.
Batteries can be inserted or removed while charging.
Batteries will turn off when fully charged.
Note: Charger will not charge any battery that the sensors indicate is too hot
or if conditions are too cold.
Note: If a battery is already charged above 50% or below 15% when charging
begins you may need to turn the battery ON to initiate charging.
WARNING – NEVER CHARGE LEAKY, DAMAGED or SWOLLEN BATTERIES –
THIS CAN CAUSE A FIRE HAZARD! Do Not charge batteries immediately
after flight, batteries must cool to “room temperature” before charging!
This product is not a toy! Not for use by children under 14 years of age.
Never leave unattended while charging.
Disconnect charger when not charging.
Never charge on or near open flame.
Do not use in rain or moisture.
Do not drop strike or impale.
Do not disassemble or alter the unit. Contact P-Squared Group for service or
repair.
Do not use an attachment not recommended for the 3DR Solo Pro PRCS.
Caution
Do not operate this unit if it has been damaged in any way. Contact P-
Squared Group for repair.
Always follow manufacturers recommended charging procedures.
P-Squared Group, LLC is not responsible for any damage to batteries that fall
out.