Pacific Image Electronics Glite T8 User manual

User Manual
Glite T8
Pacific Image Electronics
1

Product Content
» Glite T8
» User manual
» A/C Power Transformers(12V, 4.1A, DC)
» Amber Filter (in box)
» Black shading plate (in box)
Glite T8
Front
» Upper lid
» USB 2.0
» LCD Screen
» Power switch
» Light source switch
USB 2.0
Light source switch
Power switch
LCD Screen
Upper lid
2

Back
» DC power jack
» USB 2.0
» HDMI
USB 2.0
DC power jack
Interior
» Gel shooting area
» Upper lid sensor
Gel shooting area
3
HDMI
Upper lid sensor
Amber Filter

Install & use
1. Remove all fixing tape.
2. Place the Glite T8 on a flat table.
3. Connect the power supply.
4. Press the power switch.
5. Insert the USB flash drive into the USB2.0 port on the front.
6. Put the gel into gel shooting area.
7. Adjust the image exposure value to a satisfactory condition
and press the button to take a photo.
8. Press “Save” to save the photo & result to USB
4

Interface description
5

Main screen
6
①Capture
②Exposure
③B/G & WL epi, WL back
④Continuous Capture
⑤Setting
⑥Image Viewer

①Capture
7
①Capture is the button
that allows you to take
photos and capture the
gel imaging screen.
①

①Capture
8
Click Capture, and after
loading ends, you will be
redirected to the setting
screen after shooting.
Rename –Can be renamed
Negative –Can be adjusted to
invert effect
Delete –Delete this result
Save –Save this result
Delete all –Delete all results
Save all –Save all results
Return –Back to the main
screen

②Exposure
9
②Exposure allows
users to adjust the
exposure level.
Range: -10 to +10
②

③B/G & WL epi, WL back
10
③B/G is to adjusted to
Cyan's light source using
the switch on the front of
the device.
WL epi, WL back is to
adjusted to White by the
switch on the front of the
device, and it has two
modes: front light and
backlight
③
← ※Notice: Click once to initiate the light source, and
the background of the button would be white.