
IMPORTANT SAFETY INSTRUCTIONS
READ AND UNDERSTAND ALL WARNINGS AND INSTRUCTIONS BEFORE USING THIS MACHINE!
WARNING! To reduce the risk of re, electric shock, or injury:
1. You must be trained to operate this machine. This machine is to be operated for its intended use only.
2. Do not operate this machine unless it is completely assembled.
3. Always use a three-wire electrical system connected to the electrical ground. For maximum protecon against
electrical shock, use a circuit that is protected by a ground fault circuit interrupter. Consult your electrical
contractor.
4. To prevent electrical shock: Always remove the electrical plug from the electrical outlet before performing any
repairs, maintenance or cleanup and when leaving the machine unaended.
5. To prevent electrical shock: Keep the machine surface dry; Do not subject to rain; Store the machine in a dry
building area; Clean the machine with a dry cloth only.
6. Machines can cause an explosion when near ammable materials and vapors. Do not use or store this machine
with or near fuels, grain dust, solvents, thinners, or other ammable materials. Do not use ammables to clean
this machine.
7. Maintenance and repairs must be done by a qualied or authorized person.
8. If the machine is not working as it should, has been dropped, damaged, le outdoors, or dropped into water,
bring it to a service center.
9. To avoid damage to the machine’s electrical cord, always li the machine over the cord. Do not run the machine
over the elecrcal cord.
10. Make sure all labels, decals, warnings, cauons and instrucons are fastened to the machine.
This machine must be grounded. If it should malfuncon or break down, grounding provides a path of least resistance for electric current to
reduce the risk of electric shock. This machine is equipped with a cord having an equipment-grounding conductor and grounding plug. The
plug must be inserted into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
WARNING - Improper connecon of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualied electri-
cian or service person if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the machine.
If it will not t the outlet, have a proper outlet installed by a qualied electrician.
This machine is for use on a nominal 120-volt circuit, and has a grounded
plug that looks like the plug illustrated in gure A. A temporary adapter
that looks like the adapter illustrated in gures B and C may be used to
connect this plug to a 2-pole receptacle as shown in gure B if a properly
grounded outlet is not available. The temporary adapter should be
used only unl a properly grounded outlet (gure A) can be installed
by a qualied electrician. The green colored rigid ear, lug, or the like
extending from the adapter must be connected to a permanent ground
such as a properly grounded outlet box cover. Whenever the adapter
is used, it must be held in place by a metal screw.
NOTE: In Canada, the use of a temporary adapter is not permied
by the Canadian Electrical Code
EXTENSION CORDS
Use only three-wire 16/3 or larger gauge approved extension
cords that have three-prong grounding type plugs and three-pole
receptacles that accept the appliance’s plug. Replace or repair any
damaged cords or plugs.
When servicing, refer to authorized person only. Use only iden-
cal replacement parts.
Grounding Instrucons
2
NOTE: Do not use adapters shown in gures B & C in Canada