Panasonic WhisperLite FV-08VQL6 User manual

Back cover
Back cover
Back cover
Thank you for purchasing this Panasonic product.
2-3
11
6-8
5
5
FV-08VQL6 FV-11VQL6
FV-15VQL6
FV-08VQL6 FV-11VQL6
FV-15VQL6

2
Use this unit only in the manner intended by the manufacturer. If you have any questions,
contact the manufacturer.
Before servicing or cleaning unit, switch power off at service panel and lock the service
disconnecting means to prevent power from being switched on accidentally. When the
service disconnecting means cannot be locked, securely fasten a prominent warning device,
such as a tag, to the service panel.
Installation work and electrical wiring must be done by qualified person(s) in accordance with
all applicable codes and standards, including fire-rated construction.
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other
hidden utilities.
Ducted fans must always be vented to the outdoors.
If this unit is to be installed over a tub or shower, it must be marked as appropriate for the
application and be connected to a GFCI(Ground Fault Circuit Interrupter) - protected branch
circuit.
These models are UL listed for tub and shower enclosures.
For Your Safety
To reduce the risk of injury, loss of life, electric shock, fire, malfunction, and damage to
equipment or pro always observe the following safety precautions.
Explanation of symbol word panels
The following symbol word panels are used to classify and describe the level of hazard, injury, and
property damage caused when the denotation is disregarded and improper use is performed.
To reduce the risk of fire, electric shock or injury to persons, observe the following :
CAUTION
Denotes a potential hazard that could result in serious
injury or death.
Denotes a hazard that could result in minor injury.
The following symbols are used to classify and describe the type of instructions to be observed.
This symbol is used to alert users to a specific operating procedure that must not be
performed.
This symbol is used to alert users to a specific operating procedure that must be followed
in order to operate the unit safely.
WARNING
WARNING
The symbol is used to alert users not to disassemble the equipment for reconstruction
in order to reduce the risk of fire and electric shock.
This symbol is used to alert users to make sure of grounding when using the equipment
with the grounding terminal.
WARNING

Canada only: Not to be installed in a ceiling thermally insulated to a value greater than R40.
Do not disassemble the unit for reconstruction. It may cause fire or electric shock.
Ceiling joist must be subjected to static load more than five times the weight of the product.
This product must be properly grounded.
Do not install this ventilating fan where interior room temperature may
exceed 104°F(40°C).
Make sure that the electric service supply voltage is AC 120V, 60Hz.
Follow all local electrical and safety codes, as well as the National
Electrical Code (NEC) and the Occupation Safety and Health Act (OSHA).
Always disconnect the power source before working on or near the fan,
motor, light fixture or junction box.
Protect the supply wiring from sharp edges, oil, grease, hot surfaces,
chemicals or other objects.
Do not kink the supply wiring.
Provide make up air for proper ventilation.
For general ventilating use only. Do not use to exhaust hazardous or
explosive materials and vapors.
Not for use in cooking area. (Fig.B)
The special-purpose or dedicated parts, such as mounting
fixtures, must be used if such parts are provided.
3
Do not install the unit where ducts are configured as shown
in Fig.A.
Do not install with a method which is not approved in the instrucions.
Adaptor
USA only: This product has two fluorescent lamps that contain mercury. Disposal may be
regulated in your community due to environmental considerations. For disposal or recycling
information, please contact your local authorities or visit Panasonic website:
http://www.panasonic.com/environmental or call 1-888-769-0149.
CAUTION
WARNING

4
The lighting unit is an energy-saving, lighting device that uses two 13W fluorescent lamps and
produces almost the same illumination as a standard 100W incandescent lamp.
13W
Fluorescent
lamp
2
FCC Note: This equipment contains two self-ballast fluorescent lamp and is in compliance with
Part 18 of the FCC Rules as consumer RF lighting device. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
this product on and off, the user is encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect equipment into outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Warning: This equipment must be installed in accordance with installation instructions. Also, any
changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate this equipment. This device complies with Part 18 of the FCC
Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Responsible Party: Panasonic Corporation of North America
One Panasonic Way, Secaucus, New Jersey 07094
Customer Support: 1-866-292-7292

5
FV-08VQL6
FV-11VQL6
FV-15VQL6
Motor
Wiring diagram
Fan body
Night lamp
Fluorescent lamp
(Self-ballasted)
Capacitor
White
White
Neutral
Neutral
(Power supply)
AC120V 60Hz
Live
Live
Live
(VENT.)
(N.LIGHT)
(LIGHT)
Black
Black
Black
Green (Earth ground)
Earth ground
(Fuse in motor)
Junction box
10 1/4 (260)
4 3/5 (116)
4 3/5 (116)
10 1/4 (260)
Fuse type:
FV-08VQL6: ( ) Impedance - protected
FV-11VQL6: ( )
FV-15VQL6: ( ) Thermally protected
Impedance - protected
114
114
134
c
c
c

66
Fig.1
Fig.2

7
6. Refer to wiring diagram. (Wiring detail please refer
to the wiring diagram on page 5.)
Fig.3
Fig.4
Fig.5
(Night lamp)
CAUTION
Remove screw (M4X8).
Remove light cover. (Fig.6)
Fig.6
8.

8
Fig.9
Fig.10
CAUTION
CAUTION
3
9. Install the night lamp and fluorescent lamps.
(Fig.7)
10. Install light cover. (Fig.8)
Fig.7
Fig.8
(Fig.9)
(Fig.9)
(Fig.9, Fig.10)
11.
12.
Secure screw
(M4X8)

9
Fig.11
Fig.12
Fig.13
(Fig.11, Fig.12)
(Fig.13)
12 (page 7, page 8)

Fig.14
Fig.15
Fig.16
Fig.17
10
1.Clean grille. (Don’t put into hot water. Use non-abrasive
kitchen detergent, wipe dry with clean cloth) (Fig.15)
CAUTION
WARNING
(Fig.14)
(Fig.16)
(Fig.17)
12 (page 7, page 8)