Panasonic 6362 User manual

Panasonic Eco Solutions Nordic AB
Jungmansgatan 12, SE-211 19 Malmö, Sweden
Tel: [phone] •Fax: [phone]
E-mail: [e-mail] •Internet: pesn.panasonic.se
Fire alarm system
Rope elevator kit 6362
A kit with all the necessary pieces for a rope elevator.
General
6362 is a kit to make a rope elevator for a
detector and its base, e.g. detector 3304 and
analog base 3312.
The kit
The kit consists of the following:
Protective cover for detector (6360)
Cleat (to fix the rope & hang it up;
not shown in the figure above)
20 m rope (Ø2 mm polyester)
Metal plate
Two screws (to fix the base)
Two loop screws (for the rope)
Two wood screws (to fix the cleat)
Connection box (five screw term.)
Cable clamp (for the conn. box)
Rope clamp (to fix the rope)
Cable clamp (to fix the cable)
Product applications
The rope elevator is used with any of the
Panasonic heat or smoke detectors plugged
in a base, allowing the user to access a
detector mounted on a high ceiling height, in
order to perform a test, maintenance, replace
the detector, etc.

All technical features and data are subject to changes without notice, resulting from continuous development and improvement.
Product Leaflet
Date of issue
Revision / Date of revision
MEW00316
2002-12-11
3 / 2011-03-14
Type number
6362
Rope elevator kit (Detector and base are not included.)
Mounting instructions
Connection instructions
The example shows how to connect the COM loop to the Analog base 3312.
Any base of the types 3312F, 3312FL and 4313 can be used. The kit can also be used for the
conventional detector base 2324. Connections according to the Product Leaflet respectively.
Technical data
Weight (g)
~500