Panduit N2RCFR User manual

For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2016 V00029CX
Page 1 of 3
N ET -A CCESS N-Type Switch Cabinets
Part numbers:
(N2RCFR, N5RCFR, N8RCFR, N1RCFR Set of Four Cage Nut Equipment Rails
)
(N2RTFR, N5RTFR, N8RTFR, N1RTFR Set of Four Tapped Equipment Rails )
Front Equipment Rail Installation
• Remove existing front rails from cabinet posts (use T25 Torx bit to remove existing screws)
• Install [2] Front Equipment Rails to Front Cabinet Posts with [5] Countersunk Torx screws per rail (use T25 Torx bit)
• Use supplied shims (as necessary) to ensure proper EIA spacing of front equipment rails
Countersunk Torx Screw
(use T25 Torx bit)
[5] screws per rail
REMOVE EXISITING
FRONT EQUIPMENT RAILS
(use T25 Torx bit)
Shim
(**use as necessary**)
FALLING EQUIPMENT HAZARD
Remove all equipment installed onto equipment rails before performing any adjustments to equipment rail spacing.
FAILURE TO FOLLOW THESE INSTRUCTIONS CAN LEAD TO SERIOUS INJURY, DEATH, OR DAMAGE TO YOUR EQUIPMENT.
WARNING

For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2016 V00029CX
Page 2 of 3
Equipment Rail
Mounting Bracket
Rear Equipment Rail Installation
• Install [4] Equipment Rail Mounting Brackets to Equipment Rails with [3] Countersunk Torx screws per bracket (use T25 Torx bit)
• Ensure that countersunk holes of brackets are oriented to match heads of countersunk screws
Countersunk Torx Screw
(use T25 Torx bit)
Ensure that countersunk holes
of bracket match screw
NOTE - HARDWARE KITS ARE SHIPPED
INSIDE OF EQUIPMENT RAIL CHANNELS

INSTALLATION INSTRUCTIONS
© Panduit Corp. 2016 V00029CX
E-mail:
[email protected]
Phone:
866-405-6654
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp www.panduit.com
Page 3 of 3 Rev. 02
M10 Hex Head Screw
(use 15mm socket wrench)
Equipment Rail
Mount Nut
(Finger Grip Area)
Barbed Surface
(face to outside
of cabinet)
Rear Equipment Rail Installation
• Locate desired Equipment Rail position
• Insert [2] Equipment Rail Mount Nuts through slots of Front-to-Back Beam (top and bottom locations)
• Fasten [2] M10 Hex Screws to E-Rail Mount Nuts at top and bottom of Equipment Rail
• Tighten M10 Hex Head Screw to 30.0 +/- 5.0 N-m [22.1 +/- 3.7 Ft-lbs]
INSTALL EQUIPMENT RAILS
M10 Hex Head Screw
(use 15mm socket wrench)
Equipment Rail
Mount Nut
M10 Hex Head Screw
(use 15mm socket wrench)
Slot of
Front-to-Back Beam