Panduit PANZONE PZC12S User manual

INSTRUCTIONS CM315A
© Panduit Corp. 2017
FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp
2.3"
19.7"
Mouunting
Holes
25.6"
6.5" 16.0"
Mounting Holes
43.0"
Footprint with Cabinet Open
25.0"
Cabinet Width
Page 1 of 4
PANZONE Wall Mount Cabinet
Part Numbers: PZC12S, PZC12P, PZC12W
Location Footprint
PZC12S
Cabinet with Solid Door
PZC12P
Cabinet with Perforated Door
PZC12W
Cabinet with Windowed Door
Cabinet depth is 22.9” in
closed position

INSTRUCTIONS CM315A
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 2 of 4
PANZONE Wall Mount Cabinets can be installed in a hinged right or hinged left
application. For your installation, determine which side of the cabinet will hinge.
The cabinet is shown hinged right. Rotate the cabinet 180 degrees for the left
hinge application. Mounting surface must have sufficient strength to support
the cabinet with payload. The mounting surface must also be flat and extend
beyond the overall cabinet footprint.
Step 1:
Install (4) 3/8” mounting hardware (not provided) as shown in Location
Footprint. Hardware should protrude 3/8” from wall. Mount the cabinet
to the wall by hooking the keyholes over the protruding 3/8” mounting
hardware. Once the cabinet is in place, carefully swing cabinet from
wall and tighten the hardware securely.
Front Door
with Lock
7/8” Conduit Knockout
7/8” or 1 1/8” Conduit Knockout
Wireless Access
Point Knockouts
2” or 3” Conduit Knockout
2” Conduit
Knockout
Step 2:
Install door by pressing(2) hinges provided in locations shown below.
Door Hinges
Step 3:To adjust the depth of the mounting rail for specific
applications, remove the mounting screws and lockwashers,
move the rail to the desired position and re-install mounting
hardware.
Mounting Rail
Mounting Hardware

INSTRUCTIONS CM315A
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 3 of 4
Cable Routing
Cable must be routed with an adequate slack loop to prevent cable damage. Route cable to point 1 secure to tie down with a TAC-TY. Next
route cable across the bottom of the enclosure to point 2 secure to tie down with a TAC-TY.Route to the desired patch panel after securing
the cables with a Tac-Ty at point 3 or 4.
Point 2
Point 1
Point 4
Point 3
Cables Extend
to Patch Panel

INSTRUCTIONS CM315A
For instuctions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
E-mail:
[email protected]
Fax:
[phone]
www.panduit.com
Page 4 of 4
Optional Accessories
PZCRR
PANZONE Rear Equipment Rail Kit
PZCHSM2
PANZONE Horizontal Slack Manager
PZC12S
Cabinet with Solid Door
PZC12P
Cabinet with Perforated Door
PZC12W (Shown)
Cabinet with Window Door
PZBR4
PANZONE 4” Bend Radius Post Kit PZCFK
PANZONE Fan Kit