Panduit MP200 Use and care manual

DWG# 1005977 rAA
1
Firmware Update Instruction Manual
This manual guides you through downloading the latest MP200 firmware from Panduit website and updating the
firmware of your MP200.
Important!
Settings is erased due to the update.
During the update, be sure to use the AC adapter to supply the power to the printer instead of using the lithium-ion
battery or alkaline batteries.
1. Preparation
Check if your MP200 needs firmware update
Follow the procedure below to check whether your MP200 needs firmware update or not.
The firmware update is not necessary if the version is the latest one.
How to check
1. While powered on, press .
Preference screen appears.
2. Select the [Version] menu to check the firmware version.
If the version is 1000,
the firmware is old and needs to be updated.
Check the OS version of your computer
Make sure your OS version is one of the following.
Windows 7 (32bit/64bit)
Windows 8 (32bit/64bit)
Windows 8.1 (32bit/64bit)
Windows 10 (32bit/64bit)
key

DWG# 1005977 rAA
2
Download the Firmware Updater
Download “UpdaterMP200_V1100.exe” from Panduit website and save it to your desktop.
https://www.panduit.com/en/support/download-center/identification-software-firmware-and-printers.html
2. Firmware Update Procedure
Follow the procedure below to update the firmware of your MP200.
1. Put the MP200 into “update” mode
While powered off, press and hold and , then press to turn on the printer in the “update” mode.
How to confirm that the printer has entered in the update mode
A message “Downloading” appears when the printer is in the update mode.
key
key
key

DWG# 1005977 rAA
3
2. Update the firmware
CAUTION
Only one printer can be updated at a time. Do not connect two or more printers to the computer via USB.
During the update, do not turn the printer off or disconnect the USB cable.
1. Connect the printer to the computer with a USB cable.
2. Double-click “UpdaterMP200_V1100.exe” you
previously saved to your desktop.
>> Download the Firmware Updater
3. Click [OK].
Firmware update is started.
4. A screen to show that the update is in progress is
displayed during the update.
It takes about 4 to 6 minutes to complete the update, however, it
may take longer depending on the computer environment.
5. Click [OK].
The firmware update is now complete.
You can use the printer immediately after completion of the update.

DWG# 1005977 rAA
4
How to confirm if the update was completed successfully
1. Disconnect the USB cable from the printer.
2. Press .
Preference screen appears.
3. Select [Version]. The firmware version is displayed.
If the version is “1100”, the update has successfully completed.
key

DWG# 1005977 rAA
5
Troubleshoot Update Errors
Error Messages Troubleshooting
Check if the printer is in the “update” mode.
>> Put the MP200 into “update” mode
Check if the USB cable is firmly connected to the
printer and the computer. Then retry the update.
>> Update the firmware
MP200 is not connected. Put your MP200 into “update”
mode, and then connect it to the computer.

DWG# 1005977 rAA
6
Document Revision History
Revision Description of Change Date R e v. B y Approved by ECN#
AA
Initial Release MP200 Firmware
Updater Manual
3-29-2022
JSUN
ALP, JADE,
BRJO
120035/00