Panduit Atlona AT-OME-ST31A Technical manual

Atlona Technical Support: +1 877.536.3976 option 1
Update Instructions
AT-OME-ST31A
Updating the rmware can be completed using either the USB interface or the web GUI. Atlona recommends
using the web GUI for updating the rmware. However, if a network connection is not available, the AT-OME-ST31A
rmware can be updated using a USB-A to USB mini-B cable.
Using the Web GUI
Requirements:
• AT-OME-ST31A
• Firmware le
• Computer running Microsoft Windows
1. Connect an Ethernet cable from the computer, containing the rmware, to the same network where the AT-OME-
ST31A is connected.
2. Launch a web browser and enter the IP address of the AT-OME-ST31A in the address bar.
3. Login to the web GUI, then click System in the menu bar, near the top of the screen.
Choose File button
4. Click the Choose File button, under the Firmware Update section.
5. Browse to the location of the rmware le, select it, and click the Open button.
6. Click the Update button, under the Firmware Update section.
7. The following message box will be displayed.

Atlona Technical Support: +1 877.536.3976 option 1
OUTPUT DC 24VINPUT
23
RS-232
AT-OME-ST31A
1
L R
AUDIO OUT LAN
IP MODE
RESET
INPUTFW
3
2
1
PWR
LINK
OMEGATM
AT-OME-ST31A
DISPLAY
Update Instructions
Requirements:
• AT-OME-ST31A
• Firmware le
• Computer running Windows
• USB-A to USB mini-B cable
1. Disconnect power from the AT-OME-ST31A.
2. Connect a USB-A to USB mini-B cable between the PC and the rmware port on the AT-OME-ST31A. The unit
will be powered by the USB cable.
Using USB
6. Click the OK button to begin the rmware update process. Click the Cancel button to cancel the process.
7. After the rmware update process is complete, the Login screen will be displayed.
Firmware port

Atlona Technical Support: +1 877.536.3976 option 1
3. The USB UPDATE folder will be displayed.
If this folder is not displayed, automatically, select the USB UPDATE drive from Windows Explorer.
4. Delete all les from the USB UPDATE drive, if any are present.
5. Drag-and-drop the rmware le to the drive.
6. After the le has been copied, disconnect the USB cable from both the computer and the AT-OME-ST31A.
7. The rmware update process is complete.
Update Instructions