panthera 4236000 User manual

Panthera AB, Gunnebogatan 26, SE-163 53 Spånga, Sweden, [phone], www.panthera.se
ASSEMBLY INSTRUCTIONS
art.nr. 8822127
Rev.2020-12
LATERAL SUPPORT BAMBINO 3
Assembly instructions for:
Art no: 4236000 Lateral support adjustable cpl
Tool needed:
Allen key 3mm
Allen key 4 mm
Torx T20
Thin at head screwdriver.
1) Loosen the upholstery and fold it away 2) Take of the upper part of the upholstery
which is mounted with 2 pieces of torx screws on
each side.
3) Remove the plugs on top of the back tubes.
Most easily performed with a thin screwdriver.
Assembly of lateral support
4) Place the wheelchair on its side with the back
folded up, insert the ”ratchet lateral support”
(g.1 pos 6)in the respective back tubes and
fasten with screw and spacer (Fig 1 pos 7,8) with
allan key 4 mm. The ratchet is also used to adjust
the height of the lateral support.
Fig. 1

Panthera AB, Gunnebogatan 26, SE-163 53 Spånga, Sweden, [phone], www.panthera.se
The lateral upport can be mounted in two dierent ways to give dierent widths between the cushions.
Decide width mounting
1. Select position on the metal arm Fig.2
2. Make sure the plastic bushing (g1. Pos 3)inside the metal arm is
entered from above (g 3-5)
3. If the cushion is on the wrong side on the lateral support (g.1 pos.1),
x this by removing the screws (Fig 1. Pos.5) that holds the cushion, use
a 6 mm Allen key.
4. Remove the cover (Fig 1. Pos 4) and cushion and move the cushion to
the opposite side, put the lid back and screw it on.
1) Press the snap 1 to loosen the bushing
Fig 2
2) Press snap 2 to remove the bushing 3) Install the bushing from the other side
How to loosen plastic bushing
6) Mount the lateral support over the back tube
until it stops against the bolt.
7) The lateral support is in place. Ret the end
plug and screw on the upper part of the uphol-
stery, fold back the upholstery fabric.
Fig 3 Fig 4 Fig 5
wide-adjusted
narrow-adjusted
18mm smaller